Quicksilver Commander 2000 Remote Control

[Schnidly]

Hope someone can give me directions on replacing the warning horn(beeper) in my Commander 2000 Remote Control. My warning horn crackles a little and is fried I believe. Never had these apart before so I want to be cautious about getting to the warning horn. I have a diagram of the inners of the control, but if someone has a word of advice for me I'd greatly appreciate it. I purchased a warning horn for this control and just need someones direction before tearing it apart to replace the horn. I guess its near the top of the control according to the pics and it just has bullet style plugins so it should be somewhat uncomplicated to do?

 

[MH Hawker]

This may help

 

[Schnidly]

Hi Hawker, your link did not come through, can you please repost? Thanks

 

[MH Hawker]

Its a jpg so you should be able to see it.

 

[Schnidly]

Dear Hawker, your jpeg never posted for me to view. Problem on my end?? Not sure.

 

[minuteman62-64]

I can't open it either.

 

[Texasmark]

The horn is wired between the switched 12v (purple or red/purple stripe) and a tan wire that goes out to the engine via the electrical wiring harness. The tan wire connects to a tan or tan light blue stripe wire in the engine which is grounded in the engine when a failure occurs that requires the warning horn to blow. I never looked in a 2000 particularly to see the horn but have seen the ones used with the 3000 and are wired in the harness adjacent to the unit. As I recall it's a black pellet about the size of a quarter-half dollar with 2 terminals with the colors of wire connected I mentioned. I no longer have my boat nor manual for reference and this is the best I can do.

HTH,
Mark