I have a 1989 omc cobra 4.3L V6 angine. As I was cranking the engine I noticed that rusty looking cooling water was coming from under the right side of the engine(looking back at the engine). I looked under there and it was coming from an open hole (roughly 1.5 inches in diameter) just under the engine mount bracket. There is another one(sealed) of these a couple of inches way toward the rear and two on the opposite side( also sealed). I did not have water coming from that area at the end of last season and I found no missing seal in the bilge area. Any help you all might be able to send my way would be greatly appreciated.