Replacing 1976 115 transom mount - Help?

[skybolt_1]

Hey everyone,<br /><br />I have a 1976 115HP Evinrude (model# 115693D) which has a pretty rotten transom mount. I've decided to replace it, and found a used one online from a 1973 which, according to ER and a local shop, will fit. <br /><br />My question is this: How does this thing come off? There seems to be only 6 bolts that hold the whole assembly on: two at the top, and 4 at the base. However, there is a 1/3 inch or so stainless shaft that I can see that seems to be going through the whole assembly down to the gearbox. What is this, and how do I remove it? Does anyone have a copy of the schematic for this engine?<br /><br />Any help would be appreciated.

 

[Joe Reeves]

Re: Replacing 1976 115 transom mount - Help?

That is the shift rod leading to the lower unit. You'll need to disconnect it at the top in the area underneath the bottom carburetor, then drop the lower unit.

 

[piniongear]

Re: Replacing 1976 115 transom mount - Help?

Removing the transom mount may be a bear to do, especially if the engine has been run in salt water. I have a factory manual for my old 1978 Evinrude 140 and that is the same engine.<br /> If you want me to send you the section on replacing the mount, let me know. I would have to scan the section and send it to you as a PDF file and will be glad to do so if you want it. I would need your email address though...............piniongear

 

[skybolt_1]

Re: Replacing 1976 115 transom mount - Help?

hey piniongear,<br /><br />If you could send me that section I would really appreciate it!!!! My email addy is skybolt_1 at hotmail dot com. (sorry about the format - fools some spiders)<br /><br />Thanks much!