FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Hi. Helping a friend with his yamaha. On a yamaha 115 salt water 1996. To replace the water pump gasket. How to take off the plate? Do i need to take out the shaft collard? How.
Thanks
Got that, thanks. This is the picture after taken out the impeller (in pieces) What does not make sense is that the part marked with an X was inside the impeller. How do i get it into the new impeller? (grease, force...?) I do not see this part (X) in the break down.
wait a minute... you need to take off the collar and spacers to get that off.
remove parts 21, 18, 19, 20, 19.
to remove part 21, tap with a chisel upwards. take note of the order of spacers.
do a forum search here, I have posted the complete,step by step,bolt by bolt procedure.
its for a V4 but all V4 and V6 two strokes from 95 to about 2005 used the same procedure.
at least it will help keep you from asking how to get out the impeller drive key
