Restrictors bleed holes

[Award]

where can I find inserts for bleed holes or do I need them
i guess they are a nylon insert ?
thanks

 

[sam am I]

http://crowley-cloudfront.s3.amazonaws.com/media/mercuryBulletins/001/03/1992/EN_15.PDF


https://forums.iboats.com/search?sea...mercury+823829

:noidea:

https://www.crowleymarine.com/parts/258827.cfm

https://www.ebay.com/itm/New-Mercury...-/302265548241

 

[racerone]

Sam am I-----Is that the restrictor for the motor owned by Award ?----Are Mercury restrictors all the same ???----Or are there different ones for different models ?----

 

[racerone]

Award ----I use an 8-32 stainless setscrew with a 0.040" hole.-------They do not fall out !!

 

[sam am I]

Sam am I-----Is that the restrictor for the motor owned by Award ?----Are Mercury restrictors all the same ???----Or are there different ones for different models ?----

All good questions, so how does your 8-32/0.040 fit them all? Would it fit mine? or just yours and Award's?

I included a pdf so Award could make his own determination if what I had providing him would be relevant or not.....

 

[racerone]

No-----Those 8-32 setscrews do no fit all of them.----They are an improvement on the nylon ones that AWARD is asking about.

 

[Faztbullet]

The OEM is 66517.....only for inline motors.

 

[Award]

Award ----I use an 8-32 stainless setscrew with a 0.040" hole.-------They do not fall out !!

Where to you get the 8-32 set screws or do you have a pic of them
thanks racerone

 

[Award]

All good questions, so how does your 8-32/0.040 fit them all? Would it fit mine? or just yours and Award's?

I included a pdf so Award could make his own determination if what I had providing him would be relevant or not.....

I have 1978 80 hp thunderbolt in-line 4

 

[racerone]

An 8-32 setscrew 1/4" long.------I use stainless as they are easier to drill in a lathe and fixture.-----See your local hardware store / nut and bolt supply store.

 

[Award]

The OEM is 66517.....only for inline motors.

Thanks fatz
do these inserts just push in ? Do you drive them in

 

[Award]

An 8-32 setscrew 1/4" long.------I use stainless as they are easier to drill in a lathe and fixture.-----See your local hardware store / nut and bolt supply store.

Oh I thought they were something special you get lol yea I use 8-32 screws all the time being a electricians what size of hole to you drill in them are you tapping the bleeder holes I take it?