rev cam lock and retainer

[mercuryman80]

this is what im looking for part # 39021 and this spacer or retainer

 

[mercuryman80]

Re: rev cam lock and retainer

here is the pic of the part i need !! '

Thanks for you help !!!

 

[Maxz695]

Re: rev cam lock and retainer

bump

 

[mercuryman80]

Re: rev cam lock and retainer

Max,

im here in Rhode Island as i see your orig from Conn? Sweet!
The motor is 1982 Merc 80 thunderbolt inline 4cyl blueband serial # 6175131 .
the motor would not go into forward only rev unless i removed the cam and spacer now motor is shifting great into for,rev,neu but the motor will jump out of water in rev? parts look worn and dried out that i removed !

Thanks,
MM80

 

[carholme]

Re: rev cam lock and retainer

The engine will shift great with the parts removed but you will lose the ability to lock the engine when in Neutral and Reverse. It sounds like there may be nothing wrong with your parts and that you have failed to align the cam correctly at installation of the LU. As well, both the boat controls and the LU must be in the same gear before installation which is Forward for early models and Neutral for later models which your is.

Here is a link to the condensed version of the Clymer manual which shows how your configuration should be in Fig. M12-64.

http://web.ebscohost.com/serrc/pdf?...a7c7-2bd5b5ca73f2@sessionmgr111&vid=4&hid=113

Download it to your computer soonest as the link is short lived.

Gerry

 

[mercuryman80]

Re: rev cam lock and retainer

Gerry

tks busy here pulling boats ready for Sandy!! i put the LU on w box in forward! i am going to try and put back in neu and see if i can get the Cam to work ! i had tryd to download that link from above but was unable to do so ( .so i have the part # for Cam do you know the spacer part # shown above ??

Best,
MM

 

[carholme]

Re: rev cam lock and retainer

Parts List for your engine:

http://www.crowleymarine.com/mercury-outboard/678.cfm

See item 12 under DRIVE SHAFT HOUSING ASSEMBLY for the

Here is the link again to the service information:

http://web.ebscohost.com/serrc/pdf?sid=2aacd6e2-ce43-48f0-9214-59ec43ac0f56@sessionmgr4&vid=4&hid=10

Gerry

 

[Maxz695]

Re: rev cam lock and retainer

see if the part number is inside the part as like the one I posted in picture three above. According to the link above it says 52887 | GUIDE http://www.crowleymarine.com/parts/3408.cfm Notes: NOT USED WITH POWER TRIM UNITED STATES 5824647 AND BELOW AUSTRALIA 8070909 AND BELOW BELGIUM 9299905 AND BELOW CANADA 7169657 AND BELOW a few available
http://www.crowleymarine.com/parts/317416.cfm
92704 | GUIDE
Notes: NOT USED WITH POWER TRIM UNITED STATES 5824648 AND UP AUSTRALIA 8070910 AND UP BELGIUM 9299906 AND UP CANADA 7169658 AND UP

 

[mercuryman80]

Re: rev cam lock and retainer

thanks so much i did find the parts and assembled in neutral and all is well ... another Nor Eaaster here aghh this sucks boats out of water w snow all over it best of luck and happy holidays Boat Safe