Please cut and paste this list, then add your recommendations of what sealers and gasket compounds to use where. Please include complete item names and numbers and where to buy them if they are hard to find.
1) Outdrive to Pivot Housing -
This is the surfaces that you seal when you remove the OD and replace it. Add if you use gasket compound on both sides of the gasket. Do you add sealer on the outside of the joint after installing the OD?
2) Shift Cable to Pivot housing -
This is where the aft end of the shift cable threads into the back of the pivot housing. There is an O-Ring here.
3) Drain plug on starboard side of OD -
This is where you can drain water from the OD at the shift cable. There is an O-ring here.
4) The bolts that hold the OD -
The idea here is just to prevent the bolts from seizing up.
1) Outdrive to Pivot Housing -
This is the surfaces that you seal when you remove the OD and replace it. Add if you use gasket compound on both sides of the gasket. Do you add sealer on the outside of the joint after installing the OD?
2) Shift Cable to Pivot housing -
This is where the aft end of the shift cable threads into the back of the pivot housing. There is an O-Ring here.
3) Drain plug on starboard side of OD -
This is where you can drain water from the OD at the shift cable. There is an O-ring here.
4) The bolts that hold the OD -
The idea here is just to prevent the bolts from seizing up.
Last edited:
