Shift Cutout Switch Roller Position

[chriscor]

Hi there,

I have an Alpha One Gen II with a later type switch. In Neutral the plunger pin is not centered (see pic.) - drive is shifting fine. I have checked the shift cable routing, the adjustable stud and the shift cable output according to the manual. Everyting is ok. Is this an issue? If yes, what can I do

Thx

 

[chriscor]

Re: Shift Cutout Switch Roller Position

Any guidance on this?

 

[Bt Doctur]

Re: Shift Cutout Switch Roller Position

page 1C-38 http://www.boatfix.com/merc/Servmanl/6/6C1R3.PDF
may just have to remove the cable , let it center itself and reattach the cable.

 

[chriscor]

Re: Shift Cutout Switch Roller Position

page 1C-38 http://www.boatfix.com/merc/Servmanl/6/6C1R3.PDF
may just have to remove the cable , let it center itself and reattach the cable.

Thx, will try.

 

[chriscor]

Re: Shift Cutout Switch Roller Position

page 1C-38 http://www.boatfix.com/merc/Servmanl/6/6C1R3.PDF
may just have to remove the cable , let it center itself and reattach the cable.

Removed and re-installed both cables and after adjustment cutout switch roller centered itself. Thx again.