FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
2007 skeeter with push button dash,all my electrical stuff quit but engine and trolling motor work,all fuses are good,boat does not have a breaker switch,any help?
Check for a circuit breaker at the battery. Reset it if it's a manual type. If its an automatic type, check for 12 volts on the LOAD side of it. No juice at that point the breaker is bad/open. If power is there, verify at the other end of the circuit which should be the +12 volt feed to the fuse panel.
How many wires are attached to the starting battery?? Normally there are the two large cables that go directly to the engine. In addition, there normally two (one red/one black) wires (#10 gauge) that feeds the fuse/circuit breaker panel. A circuit breaker (or a fuse) is generally installed between the positive post of the battery and the red wire. There are no other wires besides the two large battery cables, then the fuse panel is powered through the engine harness. Perhaps the power at the "A" (accessory) terminal on the ignition switch was lost.
