spotty sticky gel

[sbooy42]

So I gelled the bottom of a 26' Pursuit and there are a few spots that are sticky... the rest is all hard but a couple spots just aren't getting hard....its been two weeks..
We did go over a few prior repairs that were hard... Spectrum gel...cut with dura tec per directions....
Suggestions please and thank you

 

[harleyman1975]

Only thing I can suggest is that it was not mixed thoroughly enough...Options are to leave it and see what happens or sand/remove defective areas and try to spot it in.

 

[Scott Danforth]

coat the area with PVA, if that doesnt harden it up, then you may have to start over.

 

[sbooy42]

it was PVA'd... tried heat lamps..etc Have wiped all sticky areas clean with acetone...back to square one..

Thanks for replies..

 

[Scott Danforth]

gel doesnt cure in heat, it cures in the absence of air. hence the need for a wax or PVA. if its still sticky and has a good layer of PVA, then it will need those areas re-gelled.