Stuck Steering

Berdink

Chief Petty Officer
Joined
Mar 5, 2020
Messages
537
Just an idea. Maybe others had thought of something similar. In my searching the forums, I hadn't seen this as a suggested fix for a stuck steering shaft - the shaft that the steering rod passes through - properly known as the steering tilt tube.
.
I wrapped them with clear tubing so the PB Blaster could soak and seep further into the tube.
.
It was frozen stuck and a hammer wouldn't even move it. But after soaking an hour like this, I can spin the shaft some.
.
I'll post back if successful or not, but it wasn't budging. And spraying PB Blaster at it wasn't doing it.5683.jpg

5682.jpg

5681.jpg
 

Attachments

  • IMG_20260922_123253280.jpg
    IMG_20260922_123253280.jpg
    1.8 MB · Views: 3
  • IMG_20260922_122221896.jpg
    IMG_20260922_122221896.jpg
    2.7 MB · Views: 4
Last edited:

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,181
Usually if you can rock the shift rod front to back with a pipe or monkey wrench, with penetrating oil and some rags for cleaning the dirt off, they will loosen up.

Hammering on the end will usually mushroom the end of the rod and make removal near impossible.
 

Berdink

Chief Petty Officer
Joined
Mar 5, 2020
Messages
537
Usually if you can rock the shift rod front to back with a pipe or monkey wrench, with penetrating oil and some rags for cleaning the dirt off, they will loosen up.

Hammering on the end will usually mushroom the end of the rod and make removal near impossible.
Thanks, I'll check for mushrooms, and if, I'll grind the mushroom down.
 

Mc Tool

Lieutenant Commander
Joined
Aug 7, 2024
Messages
1,961
I made up a pusher .
1000001327.jpg
steel tube with nut ( same size as end of tilt tube thread ) welded on one end , 14mm nut welded on tother , and a bit of 14mm threaded rod long enough to push the steering shaft right thru the tilt tube . Mine was really stuck ,if I tried to rotate rod the whole tilt tube would turn .
after getting it freeI put a couple of O rings on the steering rod before fitting the tilt tube nut in an effort to keep water out ....working so far :D
 
Top