Tilt Trim 3 wire to 2 Wire conversion.

[Alexander_mitchell]

(My motor is a 1995 Merc 75hp 2 stroke for reference ). So I bought a new tilt and trim with 2 wires. I bought the wiring harness with 2 relays. I have both blue and green wires connected correctly as well as both grounds from the relays. My issue is that I have no idea where to connect my positive terminals from the relays. I’m guessing they go on the starter solenoid along with main battery power terminal ? Need help.

 

[alldodge]

Welcome
Connect to same place where the Battery cable is connected.

Your drawing doesn't show a breaker or fuse

 

[Alexander_mitchell]

Welcome
Connect to same place where the Battery cable is connected.

Your drawing doesn't show a breaker or fuse

Yah I added a fuse and did exactly this. Eventually I just removed the motor and connected straight to battery to make sure it worked lol which it did. Turned out the old blue and green wiring going from relay splice to tilt/trim was all chewed up and melted previously underneath electrical tape. I then removed it and put in new 12 gauge wire. Now it works !!!! I do appreciate the help though.