FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
there should be a release valve on the lower right side,if i remember correctly it is a flat blade srew driver type.look a couple of inches above the 5 or 6 tilt pin holes you will see it ,it is recessed.
it is suppose to be torqued to 40, so it will be really hard to open. the tilt motor wires should have a bullet connector, near the tilt control box, disconnect and jump power to the wires, if the tilt works, the problem is either a solenoid, or switch.
