tilt want tilt and trim want trim

[oldboatguy]

70 hp 3 cylinder evenrude worked when I took it out for the first time
this year went up fine would not come down. let it down with the pressure
relief screw, now will no go up or down
I refilled fluid and tried to bleed out the air any thoughts the two trim cylinders will move if no weight is on them but donot trim motor the
power tilt motor runs and sounds normal . you can lift th motor manually
bu if you turn it loose if just goes down...... help

 

[boobie]

Re: tilt want tilt and trim want trim

Model # ?

 

[oldboatguy]

Re: tilt want tilt and trim want trim

Model # ?

the model is e70tlcrd

 

[boobie]

Re: tilt want tilt and trim want trim

My guess would be you have something wrong in the valve body under the tilt mtr or the coupler is broken between the tilt mtr and pump below it. If you're going to work on this yourself, get an OEM factory service manual.

 

[oldboatguy]

Re: tilt want tilt and trim want trim

My guess would be you have something wrong in the valve body under the tilt mtr or the coupler is broken between the tilt mtr and pump below it. If you're going to work on this yourself, get an OEM factory service manual.

thanks that is what I will do
I have tried to bleed the air out of the unit
the pump will move the two rams forward that control the trim but
it does not have enouhgh power to move the engine(motor)
so i don't think is the coupler but could be a valve issue

 

[boobie]

Re: tilt want tilt and trim want trim

I'm sure you've heard other t/t mtrs run before. Does yours have the nice high speed whine as others have?

 

[oldboatguy]

Re: tilt want tilt and trim want trim

I'm sure you've heard other t/t mtrs run before. Does yours have the nice high speed whine as others have?

yes it dose in up and down mode
it will build up some pressure when I bleed out
the air through the emergency release screw on the side.
It has a lot of air in the system

 

[boobie]

Re: tilt want tilt and trim want trim

Tighten up the manual release valve and get it in the full tilt position. Top off the resevior and then try to cycle it up and down. Top off the resevior again see what happens. If you get it to work,cycle it up and down five times and then check fluid level again.

 

[oldboatguy]

Re: tilt want tilt and trim want trim

ok i will try that