Trim sometimes do not push alpha one leg completly down.

[ditri]

I was rebuild cylinders on Alpha One gen II leg. Sometimes/randomly the leg is not going completly down. It stay about 1-2cm from the bottom point (if im looking on cylinders). If i pump leg completly UP with "trailer" button and if im going DOWN again - the leg is going completly down now. If im looking on the cylinder directly after that (after going completly down). I can see that the leg is going slowly up - only bit (1mm etc..). Please have somebody some advice what i should be? I was trying bleed the whole air from system but it is not easy as the manual says may be that there is some air in the system?

 

[Bondo]

Ayuh,.... Welcome Aboard,.... Run it up, 'n down 5 or 6 times, 'n go boatin',....

The thrust of the prop will push it down,....

 

[ditri]

Hi. Thank you for your answer

 

[crazy charlie]

Make sure the resevoir is at the correct level and lather some marine grease on both ss shafts and run it up and down a few times.That should be the cure.Charlie