Trying to figure out what i have

[br549dh]

Hello I drug home an old pontoon this weekend it has 19 inch tubes that are twenty three feet 5 inches long .On the end of the tubes in back the have a slightly pointed shape not much just a little.The floor joist are steel. It has a Caption Stubing wheel
[my nephew named it] Anyhow its a plastic ship stile wheel on a steel stand about 12 inches square 30 inches tall. I can not find a sn. any where. Other than needing anew floor an engine a trailer its in good condition .NO dents or tares If any one has any ideas on how to figure out what i have? That would be great Donny Thanks

 

[Cubbyblue22]

Re: Trying to figure out what i have

Did this come with any of the railing??? It sounds like it's just a project boat that was never started. Most of the time they have the ratings and descriptions on the railings. Not sure where you got it, but you should try and find the title for it, that will tell you everything you need to know.

 

[br549dh]

Re: Trying to figure out what i have

Yes it has a railing with gates on each side and one on the front. It also has a canopy that folds down . I looked all over the toons and the motor mount but i did not look on the railing. One other clue may be that on the front gate there is remnants of a decal of a ships wheel with some kind of insignia running diagonally through it. But it has been painted over. Donny

 

[lncoop]

Re: Trying to figure out what i have

Pretty sure Riviera Cruisers had the toons that came to a point on the back, but you might have a Frankentoon. Did it not come with any paperwork?

 

[5150abf]

Re: Trying to figure out what i have

I know I have seen that logo but I can't place it for sure, Riviera Cruiser sounds right though, I remember seeing toons with the pointy end caps.

 

[br549dh]

Re: Trying to figure out what i have

There not pointy like a bullet more like the straw hat that you see in Asia on people working out side

 

[EGlideRider]

Re: Trying to figure out what i have

I once owned an early 80's Smokercraft that had the fold down bimini and a similar logo. These were built in LaGrange, Ga. but I'm pretty sure was bought out by Sylvan in Indiana.

 

[lmuss53]

Re: Trying to figure out what i have

Should be a Hull ID Number on most remotely modern boats somewhere around the Starboard Stern, either attached to the decking or on a tube. I bet a picture would get it ID'ed PDQ.