Hi,
I have a 1987 SeaRay Seville BR with a 3.0L and 3.0L alpha one outdrive. About a year ago the u-joint bellow, u-joints, and gimbal bearing were all replaced. When I took my boat out for the first time this year (July 5th). The day after I notice gear oil in the floor. I drained the outdrive to check and replace the gear lube and noticed water coming out of the drive.
Long story short, I brought the boat from my father in-law and he had all the previous outdrive work performed. When he took the boat back to the shop where he had the work done, they said water was getting into the u-joint bellow due to running the boat out of the water or with the drive up. There are two cuts in the bellow on the outer ridges. Is their theory possible as to how the bellow was cut? The boat was never ran with the drive in the fully up position and it was ran out of the water to flush the outdrive when the boat was taken out crabbing. While flushing the outdrive was down. Is the shop trying to pull a fast one because a defective u-joint bellow was installed?
Thanks.
I have a 1987 SeaRay Seville BR with a 3.0L and 3.0L alpha one outdrive. About a year ago the u-joint bellow, u-joints, and gimbal bearing were all replaced. When I took my boat out for the first time this year (July 5th). The day after I notice gear oil in the floor. I drained the outdrive to check and replace the gear lube and noticed water coming out of the drive.
Long story short, I brought the boat from my father in-law and he had all the previous outdrive work performed. When he took the boat back to the shop where he had the work done, they said water was getting into the u-joint bellow due to running the boat out of the water or with the drive up. There are two cuts in the bellow on the outer ridges. Is their theory possible as to how the bellow was cut? The boat was never ran with the drive in the fully up position and it was ran out of the water to flush the outdrive when the boat was taken out crabbing. While flushing the outdrive was down. Is the shop trying to pull a fast one because a defective u-joint bellow was installed?
Thanks.