I just installed my new helm. This is a uniflex rotary system. Now on the helm is two 3.5 inch bolts that slide into nylock I beleive these are the bolts that hold the cables in place. Now I was only able to tighten these down to the threads on the nylocks. There is still 2 inches exposed. The measured the bolt against the helm housing and it seems to be long enough to rrecess all the way down but the shoulder of the bolts are bigger then the nylock. They say to torque to 6lbs, this i did. Well, just looking for a little guidance because the instructions didnt say anything about the bolts needing to be flush with the housing. I do have only a quarter of an inch play in the steering wheel. Not bad for my first time.
Thanks
Thanks