FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Racer,
I sent Evinrude an email requesting information on compatibility. Best I can tell by studying diagrams, the '89-97 35,40 and 50 horse motors that have PTT will work.
Your motor has the tilt assist feature, doesn't it? Just my opinion, but seems like a lot to go through. Might consider aftermarket t.&t. units as a little simpler route to go.
Your motor has the tilt assist feature, doesn't it? Just my opinion, but seems like a lot to go through. Might consider aftermarket t.&t. units as a little simpler route to go.
The tilt assist is frozen. I don't want to spend $600 on aftermarket. Plan is to find a donor motor with bad powerhead for cheap. I'm not in a hurry so given the time I'm confident one will turn up.
An obvious point, but wouldn't it be easier/cheaper to find a replacement for the tilt assist. I haven't used it on the water, but played with it on a 65(?) hp that I was looking at. With that device, it seemed to me that setting the manual trim would be pretty easy.
