Yamaha F115

Ed O'Neill

Cadet
Thread starter
Joined
Apr 9, 2005
Messages
13
Started the engine this morning and it would not emit water from the small **** hole. I turned off the engine waited a moment and tried again. No luck the engine would not emit water from the small **** hole. I pulled the boat out of the water and attempted it again on land with "earmuffs". No Luck, I inspected under the cover and there were no broken water lines. I dropped the lower unit and the water pump was fine, the impeller was nearly perfect. <br /><br />Any ideas? I was thinking maybe its a bad thermostat ?
 

rodbolt

Supreme Mariner
Joined
Sep 1, 2003
Messages
20,066
Re: Yamaha F115

most likly a clogged tube or outlet tube. try blowing air back through it. the fuel cooler will clog occasionally as well.
 

Ed O'Neill

Cadet
Thread starter
Joined
Apr 9, 2005
Messages
13
Re: Yamaha F115

When I had the earmuffs on the engine when it was running but not "pissing" I placed my finger over the **** hole and it was sucking air in.
 

ub520

Recruit
Joined
May 12, 2007
Messages
5
Re: Yamaha F115

chek to if there is no mud wasps nests in the tell tal pipes or ants nests.
 

Ben Paquin

Seaman Apprentice
Joined
Sep 2, 2007
Messages
45
Re: Yamaha F115

I had the same problem on my 1990 115 yamaha. The water pressure was fine on the gauge and it did not seem to overheat. Ran it for a while (45 minutes) @ various RPM. Next thing I knew the water was shooting strong through the telltale
It was clogged.
Just make sure you do have water pressure
 
Top