Just a few more questions.
Here is a pressure regulator with attached gauge to get the fuel pressure dialed in.
Speedway Fuel Pressure Regulator 5-12 psi & Gauge 0-15 psi
I can attach it directly to the Volvo low pressure pump and filter housing to make a clean installation.
Should I use a hard...
That would be great! Should I put a regulator on it or use it as is?
That will help keep everything looking stock using the low pressure pump and filter setup.
Thanks for the info
I have been doing a lot of research on this project. I ordered a good used 5.7 GL wiring harness. It has the relay for the single fuel pump.
Can I use the stock intake Chevy manifold (PN 14096242)? I have read that there is a plate adapter for the TBI and a Edelbrock 1409 will be a direct fit...
Here are a couple of pictures of the STBD side ecm plug. I ended up putting heat shrink on all the bare wires. The wires seem brittle. I don’t trust it to be reliable. If I could find a used replacement plug I could splice it in.
I can find a 5.7 GL wiring harness. Would that work if I...
The TBI was just rebuilt. Both pumps are working. I have a strong feeling the VST has problems. So everything is new except the VST. Not sure if I can work on it.
Thanks
I have recently bought a 1996 2460 pursuit with a Volvo penta 5.7 GI with TBI.
The engine only has 80 hours on a rebuild. The problem that I am having is low fuel pressure and the wiring harness is bad.
I have replaced the tank fuel tube, check valve, fuel line, both fuel filters, both fuel...