I have water leaking in to the lower cowling but can't manage to find the source.
Engine has 110# on both cylinders so I am kinda ruling out the head gasket. Any ideas on a source or trick to find it? Could the power head gasket be leaking water out?
Thanks
I got a 25hp 74 sporter rude that is in excellent shape. but cant get it running smooth, new points condensers, etc.
Now I have a donor motor 84 20hp WITH A GOOD IGNITION SYSTEN CAN I SWAP HESE OUT TO THE 74? Is the cam follower in the way? is the crank shaft the same size to interchange the...
Ok have a excellent short shaft early 80's 9.9, have a bad lower unit that is a long shaft.
want to make the shorty long! have the LU out, how do you get the drive shaft out of the lower unit?
Have all the parts for the conversion just have some confusion on the shaft removal from the Lower...
1st : Just cleaned the carb and trying to set up the Idle, but I can screw the low speed needle in all the way, it revs up by still runs and no boging. The previous owner was trying to lower the idle using the screw stop on the cam follower? on the side(left side looking at it from the front)...
I have replaced the points and condensers. now I got no spark on the bottom cylinder.
I think I must have a wiring/issue.
1.I have continuity across the two trigger wire to the plug coils with one of the points at the full oppenposition(.020) and the other fully closed.
2. I have a...
ok, I have a 74 evinrude 25hp
NEw to me and I had it running, check the spark on the cylinders and the bottom one was weak.
So I replace the points and condensers, now no spark on the bottom. It actually gave me a small weak spark on first try then nothing since.
Both plugs will spark...
I got a 2003 60 hp sea pro tiller model, manual start. I was wondering what I needed to set up a charging system for my bilge and light battery. I Have two unused yellow wires coming from the stator. I assume I need a recitifer. Any part numbers?
I have no e start system at all no keys...
The motor seemed to idle fine,
surges while at mid and high speed trying to maintain it, but ultimately slows back down. if you bring the throtle back and try to go again it makes the attemp again and fall flat again.
This issue may be related to cold weather operation as I had similar...
First, it work fine all summer and then last week the trim got slow during the trim up movement. And then today when I took my boat off its mooring, I could hear the relays click but no motor running, evenually it click in once slowly and then could not get it to start again.
Motor gone or a...
I got a 1965 8hp sea king,
Model vwb19039a
serial 66x13092
Looking for a impeller part # for this,
anyone got one?
thanks for your help.
Scott
aslo looking for the recoil spool part #
Good day got a late 60's early 70's 9.6 viking, Having trouble starting.
model 94121
ser 1821
I got it last year had it running once in the tank, after cleaning and setting up the points. After I shut it down it made a little pop sound 2 mins latter?
Anyhow check the spark, it was weak...
OK, I picked up a complete 1999 40hp commercial with motor trouble for 300bucks.
At the time it would rotate but with some binding, up on removal of the head there is water in the crank. I was told it was left on the boat at the edge of the saltwater. They assume it took salt water in thru the...
At Idle and in neutral the motor works fine, you can rev it right up in neutral. Put the motor in gear and she make the attemp to rev up and then just goes back to basically an idle and just putts around the harbour. Motor is not runnning rough. At one point it ran good in gear for about 10...
