Jeff J's latest activity

The dust cap or bearing buddy provides the seal on the front. That’s why those rubber pieces need replaced on the caps used with axles...

Personally, I would not fill the hub if there is no zerk fitting. I don’t use the zerk fitting even if there is one. I do spread some...

I like K&N filters but feel 2 are needed because the cleaning and oiling process takes a considerable amount of time. It’s nice to have...

I would take the 2 bigger eggs in the lower corners. Otherwise, I tend to pull eggs in the order that keeps the carton best balanced for...

I only buy my E0 (non-oxy) from stations that I know sell a lot of the stuff. They get enough business so that the gas is replenished on...

The issue is this: this is all being done for political and economic reasons adding ethanol to motor fuel raises octane but causes many...

Not bad advice. I swap them out as they fail {if ain’t broke don’t fix it}. The fixtures usually seem to be bad enough swapping the bulb...

If your gonna do one then do them all. It's a messy job. One time and done.

I almost never wipe a bearing with a towel or rag. I typically clean my bearings in a can of mineral spirits, sometimes use gasoline, by...

all speculative.....biased opinion. it's a massive gamble to bet on an EV battery pack....my biased opinion.

I have made five 1,000 trips dragging a trailer in the 2 months. Probably have at least five trips remaining. That is two ten hours days...

The problem I see with electric cars is the costs of battery replacement can easily exceed the value of the vehicle. That is why the...

This is why I insist my vehicles have a factory trailer tow package on them. With today's funky wiring systems, the problem is solved...

Correction: my bad experience with the parts counter happened at the Honda dealer. I let him verify my part numbers then he sold me the...

Hole, split or other air leak in the plunger?