My 1961 Evinrude Fastwin 18 slipped and fell over landing on the shifting lever/arm. Being pot metal it didn't have a chance. My question is Do I need to remove the power head to replace the shifting arm. This is on A Model 15034 1961 Evinrude Fastwin 18. Any and all help is appreciated. Eric.
Major possibility it's Coosa Board. A fiberglass reinforced polymer material. Does not rot, lighter than wood, lasts forever. However the down side is cost. If that's not a concern, check them out. Coolant Fiber Board.
Hello everyone. A few years ago, I purchased a 16' Ebbtide Dyna-Trak 160. Had every intention of having it in the water by now. However, Life got in the way. Both my life partner and myself have had some medical issues and it's been stored. to say it needs some TLC would be an understatement. I...
Hey everyone, I have a 1973 65hp "Triumph" outboard that the previous owner took of a new to him pontoon boat prior to selling this Ebbtide 160 tri V to me. It did not have trim and tilt on it. My question is can a trim and tilt unit be added to this motor. I really don't want to put a jackplate...
I am not going to argue about what year was the last year of what, but everything I have found on ID-ing this motor says it's an Evinrude 65hp Triumph outboard produced in 1973. Designed for saltwater use. model number 65373R...and that came from right here on iboats when looking it up...just sayin'
My Location is Springfield, Missouri. Doing research the photos of the units said to be same as mine had only the drive shaft and an electric wire coming out the top. Thats why i referred to the electric shift. However, thank you for setting mestraight
I have a 1973 Evinrude 65HP Triumph outboard. Model number 65373R. It wasn't drained properly and the lower unit cracked from the propeller end toward the front. I was told this unit isa Hydro-Mechanical unit that uses electronic shift, andan oil pump, and a newer late 75-77 mechanical shift...
