Recent content by lazyMlazyK

  1. lazyMlazyK

    1979 75HP Evinrude 75943R - Throttle Issues

    I have no tachometer, but the RPMs sound correct for 7mph when it wants to run that way, and the RPMs sound correct when it is running normally at 35mph. The speed and RPMs seem to make sense together, regardless of the speed. The vibration that I'm seeing is only when it's low RPM and low...
  2. lazyMlazyK

    1979 75HP Evinrude 75943R - Throttle Issues

    Hey all, I've got a new issue with my old 75hp Evinrude outboard. Sometimes when I switch from idling to forward gear, then wide open throttle, I get some vibration and wide open throttle only gets me up to around 7mph. Usually gets up to around 35mph with my current boat. Usually, if I leave...
  3. lazyMlazyK

    1979 Evinrude 75HP - Swivel Bracket

    Anyone?
  4. lazyMlazyK

    1979 Evinrude 75HP - Swivel Bracket

    Thanks all. Does anyone know the difference between the part numbers shown here, other than cost?
  5. lazyMlazyK

    1979 Evinrude 75HP - Swivel Bracket

    Not in Canada, but pretty close. North Dakota :D How are the brackets measured? Is the bracket the same size for a 15" transom and a 20" transom? I would think so, but it appears they have separate part numbers.
  6. lazyMlazyK

    1979 Evinrude 75HP - Swivel Bracket

    Correct assumption, no transom saver was used then, just the tilt arms. I drove over a small but rough bridge in town and heard when it broke bouncing on that bridge. Transom saver has been used since.
  7. lazyMlazyK

    1979 Evinrude 75HP - Swivel Bracket

    I've got a 1979 Evinrude, 75 HP, model 75943R, serial No. J0001976. This came on my first/current boat, and I learned the hard lesson that tilt arms are not meant for trailering. Anyway, one tilt arm broke, and the bolt hole for the starboard tilt arm broke out too. Is there any way to repair...
See more
Top