Recent content by montauk1

wont jump 1/2 gap? Where should I start testing? I get power to starter so motor will crank. I did notice with a probe that the #3 #4 #5 #6 posts are weak That would be Grey,Red,Red,and Red Grey Stripe.:confused:

I have 4 by pass cover cylnders, two have small fuel line connectors and two dont, can any one please tell me the proper cyl each one goes to.

Would anybody have a diagram or chart of where all the bolts go. trying to put together my power head. Thanks

Has anybody painted or restored a hood - cowling, I dont think Johnson painted these in 1988, is there a compound and polish to use, or should I paint it? Its realy not that bad just a little dull and dirty. Thanks

I removed all the bolts my manual had described and cant get the lower unit to seperate from the exuast. any suggestions.

1988 Johnson 90hp got stuck in the mud, really overheated started burning white smoke. Obviously it wont start right now, does anybody have a list of things to start checking before I bring it to the shop. Thanks

New fuel pump, vro has been by passed, rebuilt carbs, motor runs great at any speed except idle. Idles great in drive way, idles great at first cold start. After warmed up idle dies. WHAT DO YOU EXPERTS THINK!!!!!!!

Can any body give me the correct procedure to do a Sync and Link on a 1988 Johnson 90hp

WHat is the proper procedure to do a sync and link? Do you have to be on the water?

Replaced VRO pump and replace with pre mix fuel pump. New Plugs gap at .040 . New fuel pump, Re built Carbs. Motor ran great for a while now quits at WOT. Help

Hi 1988 Johnson 90hp (vro by passed). Has a little problem starting at the ramp, once at idle runs great! Getting outside the Harbor I start to excelarate to faster RPM's runs good for about 3-5 minutes and then engine sounds like it is running out of gas and dies. Then it is really hard to...