Recent content by Pink-Panthered

Re: Made a little progress Re: Made a little progress What is this piece on the bottom. It rotates? And a cutting board i made out of some scraps (18 x 24ish) How do i make the pictures show up big?

Made a little progress Made a little progress Here is some of my progress of late: Made an Outboard stand following the basic pattern of the one linked on page 2. I had some half cans of spray paint that froze this winter, so i burned them up to form a moisture barrier. Since the pictures, i...

Re: Potential for complete loss? The joint between the hull and the cap. How does one fix that?

Re: Potential for complete loss? Got the outboard off And the cap split

Re: Potential for complete loss? I am not proud to admit this, but it needs to be documented. The piece of decking that was in the bow had glass securing it to the hull. I assume it was original and has never been replaced. I took a grinder with a cut off wheel and traced the outside. Cut the...

Re: Potential for complete loss? Where to begin??? It needs a transom. I would bet on that. I hope the stringers are solid enough I can leave them. But I am afraid the cap will have to come off. To be honest, part of the allure of this boat was it was cheap. If it needs a new transom...

Re: Potential for complete loss? Here are some pictures of her, like i promised: Here is a picture of the stringers: Here is a picture of the hole in the hull, with a close up: Here you can see some damage on a stringer: Another:

Re: Potential for complete loss? You can see the hole where the front cross member on the trailer lies perpendicular to the tongue.

Good Morning Everyone, I am new to this site. Just joined today. A guy I work with generously gave me a 1978 Crestliner Apollo 660. It has a 40 ft. lb. trolling motor on the front, and a Evinrude 115 on the back. Here is the story on the boat, and probably the reason it was given to me...