If in fact you are using waxed resin you must sand/ grind between coats. The wax layer floats to the top and will prevent a good bond without getting rid of it.
Timing issue definitely was the CDI or coil as I call it. Swapped 3 for 1 timing now adjustable. Suggesting replacing all coils. This unit fires and ohms out. Don’t understand why it would not let me adjust the timing.
Trigger didn’t make any difference. I am going to try swapping coils. From what I am seeing only two coils of the stator charges the CDI or coil. Trigger wheel sets spark time. My thoughts now is either CDI coil or flywheel .
I have a 2001 50 Mercury that I can’t get the timing correct on. It is against the stop at 10BTC and goes out of view at full throttle. Could this issue be related to the ignition trigger
Bring up a really dead thread. Many years later some of my wood work has rotted again. Seats that I covered are stained. Dang neighbors cats. My old girl has been sitting since 2017. One shot of carb cleaner that was left in the boat and she banged right off. New tires on order. New water pump...
Needing help with choosing new paint for our house boat. We have used Interlux Brightside paint every year for the blue trim. It fades and chalks within a year and must be repainted every year. Looking for what you use and how long it has lasted. Outside uncovered all the time.
I do not know if this has been covered here but 4 children died the week of the forth because of ESD. I have tried to gather information to see what can prevent this from occurring. I have found several types of dock systems but they are expensive and I do not expect to see any docks switch to...
I have a 69 model dana 90 with a squeal in reverse. Forward is quiet. Drives were serviced earlier this year. Ran 25 miles to dock with no problems. Sat idle until this week. Anyone experienced this?
