Recent content by TEXAS ROD WORKS

  1. T

    repower ??????

    I am running a 20' twin vee that is rated from 90hp-140hp, I have a 1999 johnson 90hp 60degree looper on it now. The ? is I am thinking of switching to a 3 cylinder 90hp motor (yamaha or tohatsu) will i notice any loss of power with the loss of the 4th cylinder ?
  2. T

    1999 johnson 90 hp fuel problem???????

    I have a johnson 90 ,1999 mod, prob is that when you run it up to 4500 rpm's it will run great for bout 300yds then it will start to act fuel starved, if i pump the bulb it will run fine. I have put 2 diff vro pumps on , changed the vapor sep. commpression on all 4 within 10psi. what next? none...
  3. T

    1999 90hp johnson problem!!!!

    I bought a new boat that has a 1999 90hp on it , motor runs great ,when you run it wide open it will go bought 500yds and then act fuel starved. the guy that had it before me put a 5psi priming pump in line between the fuel filter and the tank. I have changed the vro pump and also bipassed the...
  4. T

    Steering Problem

    I Have A 20ft Twin Vee The Boat Wants To Steer To Starboard , I Have Tried To Adjust The Trim Tab On The Motor It Does Not Help Much . What Next?
  5. T

    problems with newly rebuit 1981 70omc!!!!!

    I recently rebuit an 1981 Johnson 70 ...............1rst problem is that it wants to idle way to high to put into gear,2nd when you do put it in gear and return to neutral the idle lever on the box pops up........3rd if you put it in gear and try to give it some gas it bogs down and dies ,it has...
  6. T

    I need omc remote info???????????

    anyone know how to convert the new style omc control box with the black plug over to the older red plug??????????
  7. T

    Idle lever pops up in neutral????????????

    I recently rebuilt an 81' 70hp johnson , now the hi-idle lever will not keep poping up in neutral ?????????
  8. T

    anyone know how to install new dowel pins in an engine block????

    I had to remove the three dowel pins from an 81' 70 omc anyone know the best way to put the new ones in????????
  9. T

    81' 70 johnson crank bearing dowel pin ???????

    i have an 81' 70 johnson , during the installation of new pistons the crank bearings did not get lined up with the dowel pins. Now the pins have been pushed into the case slightly ..................the question is can they be removed and can i get new ones???????
  10. T

    1981 70 johnson?????

    the dowel pins in the crankcase do not have line up holes in the bearing sleeves???????(or do they)?????
  11. T

    '81 70hp johnson powerhead torque specs

    does n/e one know what the powerhead torque specs for this motor
  12. T

    84 Johnson 50hp Grinding Going Into Rev

    I Have An 84 Johnson 50 , It Slightly Grinds Going Into Rev . I Have Checked To See If It Goes In Freely (manualy) And It Does . On The Cable Adjustment If I Go Anymore Towards Rev It Grinds In Forward . Anyone Have A Remedy???? Thanks For The Help...................dave
  13. T

    Question About Removing Tilt N Trim From 84 50hp Johnson!!!!!

    I Have A 1984 Johnson 50 That Had The Add On T-n- T , The Unit Was Bad So I Have Removed It . The ? Is What Parts Do I Need To Add To Lock The Motor In Place On The Trim Pin (in Rev The Motor Will Kick Up) Any Help Would Be Great Thankx...................dave
See more
Top