power trim removal of center cylinder

acadian2022 · 2025-09-12T13:57:23-0600

good day all. could someone explain how to remove single center cylinder for a replacement see pictures. I see the top part will be a pin to knock out its the bottom one not sure how to go about it. thank you all

airshot · 2025-09-12T15:45:45-0600

What year and model ?

acadian2022 · 2025-09-12T16:19:50-0600

airshot said:
What year and model ?

hi. it's a hard one to figure out have another post open but we think 1982 V6 200 HP

boscoe99 · 2025-09-12T16:24:05-0600

What is the engine serial number?

airshot · 2025-09-12T18:59:23-0600

I have q manual, but for a much smaller motor, so probably can't help

acadian2022 · 2025-09-13T01:33:46-0600

no problem. thank you

acadian2022 · 2025-09-13T02:58:10-0600

acadian2022 said:
good day all. could someone explain how to remove single center cylinder for a replacement see pictures. I see the top part will be a pin to knock out its the bottom one not sure how to go about it. thank you all

hi all. I assume I need a puller of sort my concern this is was used as a salt water engine and when I removed those covers to expose the center pin with center threaded hole I'm assuming it's going to seized had slat deposits inside of the cover. will spray penetrate WD-40. I have another post regarding this engine wanted to seperate the topic thank you once again for any help on this.

acadian2022 · 2025-09-13T05:19:00-0600

acadian2022 said:
hi all. I assume I need a puller of sort my concern this is was used as a salt water engine and when I removed those covers to expose the center pin with center threaded hole I'm assuming it's going to seized had slat deposits inside of the cover. will spray penetrate WD-40. I have another post regarding this engine wanted to seperate the topic thank you once again for any help on this.

perhaps the center hole is a reverse tread bolt that is required?

acadian2022 · 2025-09-13T05:21:18-0600

acadian2022 said:
good day all. could someone explain how to remove single center cylinder for a replacement see pictures. I see the top part will be a pin to knock out its the bottom one not sure how to go about it. thank you all

racerone · 2025-09-13T05:54:36-0600

I think you put a threaded rod in there.----And a slide hammer.----Perhaps your local friendly shop will pull it in minutes.

acadian2022 · 2025-09-13T05:56:05-0600

I was thinking about that... and have such a tool

what the heck will give that a try thank you...

power trim removal of center cylinder

Seaman

Attachments

Vice Admiral

Seaman

Commander

Vice Admiral

Seaman

Seaman

Seaman

Seaman

Attachments

Supreme Mariner

Seaman