power trim removal of center cylinder

[acadian2022]

good day all. could someone explain how to remove single center cylinder for a replacement see pictures. I see the top part will be a pin to knock out its the bottom one not sure how to go about it. thank you all

 

[airshot]

What year and model ?

 

[acadian2022]

What year and model ?

hi. it's a hard one to figure out have another post open but we think 1982 V6 200 HP

 

[boscoe99]

What is the engine serial number?

 

[airshot]

I have q manual, but for a much smaller motor, so probably can't help

 

[acadian2022]

no problem. thank you

 

[acadian2022]

good day all. could someone explain how to remove single center cylinder for a replacement see pictures. I see the top part will be a pin to knock out its the bottom one not sure how to go about it. thank you all

hi all. I assume I need a puller of sort my concern this is was used as a salt water engine and when I removed those covers to expose the center pin with center threaded hole I'm assuming it's going to seized had slat deposits inside of the cover. will spray penetrate WD-40. I have another post regarding this engine wanted to seperate the topic thank you once again for any help on this.

 

[acadian2022]

hi all. I assume I need a puller of sort my concern this is was used as a salt water engine and when I removed those covers to expose the center pin with center threaded hole I'm assuming it's going to seized had slat deposits inside of the cover. will spray penetrate WD-40. I have another post regarding this engine wanted to seperate the topic thank you once again for any help on this.

perhaps the center hole is a reverse tread bolt that is required?

 

[acadian2022]

good day all. could someone explain how to remove single center cylinder for a replacement see pictures. I see the top part will be a pin to knock out its the bottom one not sure how to go about it. thank you all

 

[racerone]

I think you put a threaded rod in there.----And a slide hammer.----Perhaps your local friendly shop will pull it in minutes.

 

[acadian2022]

I was thinking about that... and have such a tool what the heck will give that a try thank you...