Search results

  1. B

    '85 8hp Evinrude carburetor attachment bolts replaceable?

    It is a model E8RCOB and the threads are bad on one of the bolts that hold the carb on. Are they replaceable through the back? Thanks.
  2. B

    Will 8" wheels last for 1400 miles?

    I have one similiar to Northern Tools boat trailer. It has a 14' wide and deep open aluminum or steel hulled boat on it. We might put a 46" riding mower or other stuff in it too. Are the bearings and wheels good enough to go 1400 miles in 3 days? Thanks.
  3. B

    3 different forums and no solution for 9.9hp lack of power

    1992 Johnson 9.9 J10RENA idles great but won't get up on plane. It has a new carb kit, redesigned carb cover, fuel pump kit, spark plugs, fuel lines. and a fuel filter between the fuel pump and carb. The carb has been cleaned about 10X. The high speed jet was clean when I took it apart the...
  4. B

    How do I re-sync the motor on '92 9.9hp?

    It's a J10Rena Johnson motor. Thanks.
  5. B

    How can a switchbox go bad just sitting there?

    Take a 50 hp 2 stroke 3 cyl. Mariner for example I think they call the box with all the wires going to it a switchbox. We put this motor on that back porch and after 3 years it lost the spark. What would cause it to go back under these circumstances?
  6. B

    Johnson 9.9 gags, timing question too

    This motor is a '92 J10Rena with a manual starter. I put a new carb cover kit on it along with a carb kit. It idles ok but it won't get any kind of power unless you run it a full throttle for a bit and back off 1/4" then it moves right along although I'm not sure that the best it will do. If...
  7. B

    How does '92 9.9hp starter install?

    It's been over a year since I took this thing off and the library manuals don't show a picture. I tried leaving the red cam lever on the outside of the vertical starter bar but the speed control wouldn't move. Does the red bar go inside the vertical bar on the outside edge of the starter? And...
  8. B

    Shouldn't water go through the system?

    I have a 1992 Johnson 9.9hp J10Rena that pumps water to the thermostat. If I turn a hose loose inside the thermostat hole water comes out the pee hole. Yet when I put the therm cover on without the thermostat, no water get to the pee hole. The thermostat is new but I notices there should be...
  9. B

    Are there any states that don't require any paperwork on a boat to get title?

    We bought a boat off a neighbor and he lied about having a title. I told him the last two owners didn't have any paperwork. He might send me a bill of sale if the minister tells him to do so. These last two guys haven't cooperated that I know of and I don't expect much now. This boat has never...
  10. B

    Sears Gamefisher groaning-rubbing noise

    At low to medium speeds the motor vibrates and really makes a loud groaning noise and rubbing kind of noise. What would cause that and is it diffficult to repair? Thanks.
  11. B

    Late 70's 50hp Mariner lost spark just sitting

    Hi, This is all the information there is on the motor... Mariner 50hp late 70?s block no 0244350, 3 cylinder It sat on the porch for 2-3 years and was running when last used. Now there isn't any spark. I cleaned all the wire connections possible, which didn't help. The motor turns over of...
  12. B

    Motor Guide Great White GWB52V switch

    Hi, We have this trolling motor and according to the schematic, a 3 position switch is missing. I can't figure out where it fastens down inside the motor head or how to turn it on outside the head. The 3 wires that go to the switch are loose of course. I can get it to run in reverse but not...
  13. B

    Sears 3hp gamefisher air adjustment setting?

    Hi, Here's what I have... Sears Gamefisher Model 298586193 No. 14608 3hp I had to take out the air adjustment needle for cleaning. Since I thought it was a normal mixture needle I didn't check to see how many turns out it was. The motor would run awhile and quit, then leak gas out the air...
  14. B

    '79 35hp Johnson dies or hesitates, lack of fuel?

    Johnson 35 hp Key B507 35EL79A E5086019 I put in a new fuel pump kit just the way the directions showed. The motor idles great, but when accelerating it hestitates and acted like it wanted to die or did quit. I put two used plugs in until I can get new ones. It will now go up to high speed but...
  15. B

    How do I wire this electric davit motor?

    The starter markings include L1,1,2,3,4,5, and L2. 2 and L2 appear to be the same post. There is a blue wire going to L1 and then to 3. Yellow wire to L2 & 2 orange to 3 I need to wire Black, red, orange, white and green wires from a Furnas Reversing drum switch to this motor. Thanks.
  16. B

    Sears Gamefishier 3hp drive shaft won't turn

    This motor sat in salt water overnight and I found it the next day. I washed the head and cqrb out and got used it several times as a trolling motor before letting it set for 6 months. Now the motor runs but the prop doesn't turn. I got the parts diagram off Sears but it doesn't say anything...
  17. B

    Was the '92 Johnson 9.9 hp carburetor faulty?

    I read that the plastic top of the carburetor wasn't held down securely enough and it was recalled. My plastic top has a bolt that goes in the side and hods the cam roller on. Johnson J10RENA. Anyone know something about this? Do I need a new carburetor or a kit? Thanks.
  18. B

    Where does water come out of TN26 5hp

    There is a hole in an elbow just below the power head and water comes out there, but not the two exhaust holes. Is this normal? The impeller is worn but not bad either. Thanks. Bob
  19. B

    Does the Mikuni fuel pump work on RD19 35hp?

    It says it pump 17 liters per hour. Will it work on the 35? Part is 07-00777 from Aircraft Spruce. Not bad for $20.00 I've seen a Johnson/evinrude pump listed for the 18hp but I don't know if it will work on this model or not. Thanks.
  20. B

    How does Tn-26 water system work?

    The two exhaust holes are clear 1/2 way up the motor but no water is coming out. I took the lower unit off but no impeller. Thanks.
Top