Search results

  1. J

    Y pipe

    I was looking back towards inside of transom so by left side I meant starboard side..I am going to take it back to water tomorrow and see if what I've sealed stopped it...if not I'll pull drive and check the ring inside like you suggested
  2. J

    Y pipe

    Alright so I've ran boat for an hour in driveway...no leak...my conclusion is it's not y pipe...I have checked all bellows and snughed up clamps...also pulled the plugs leading into steering arm are and sealed them. Also ran another good wide bead of sikaflex around bellhousing and around the 2...
  3. J

    Y pipe

    Early alpha 1 sorry
  4. J

    Y pipe

    Ok so after reinstalling a new bell housing gasket...housing..outdrive...y pipe...and engine. I had it fired up on hose and there was no leaks anywhere aside from a bad clamp. I took it to dock today and just backed in and fired it up and ran it...I've got a leak and it appears to be left side...
  5. J

    Stringers

    That is kinda what I figured. I can honestly say it has way more strength now then it did when I pulled it apart no bulkheads...rotten and soaked stringers. Rotten and soaked transom.
  6. J

    Stringers

    That portion is done...it's from there forward that isn't...it's wide open for me to finish.
  7. J

    Stringers

    Good day....I have finished my transom and engine and outdrive back in place. Stringers are tabbed in but not finished. I need to move my boat about a 20 min drive. Is it safe to do so or will I crack something
  8. J

    Alignment tool stuck

    Outdrive slide right on...had to turn prop twice and she slid home
  9. J

    Alignment tool stuck

    I went and bought a good slide hammer set...welded a chain on straight...a few smacks and out she came. I them did some trial and errors and got the tool sliding fully in and easy out. Thanks gentleman
  10. J

    Alignment tool stuck

    The drive came off easy and I didn't change bearing. What did change and I should have mentioned is the transom has been rebuilt. I'm guessing the holes are off a tad. Can't be much though or it wouldn't have slid in relatively easy. I'll weld
  11. J

    Alignment tool stuck

    Ya it ain't coming out...I don't get it...shall I raise or lower engine mounts ...
  12. J

    Alignment tool stuck

    Alright I'll give the slide hammer trick a go...I hooked up wiring and bumped starter...didn't help...boat started though lol. It seems really stuck...
  13. J

    Alignment tool stuck

    No adjustments no....I'll try the starter bump and just keep working at it
  14. J

    Alignment tool stuck

    It went in pretty easy . Definitely didn't have to fight it in. I haven't re installed all my wiring yet
  15. J

    Alignment tool stuck

    Good day fellas...I have managed to get my tool stuck....again....gen 1...it fully slid in to coupler and its cam back a bit but now stuck and I can't remember how I got it out before. Help please
  16. J

    Stringer install

    To fill in gaps
  17. J

    Stringer install

    Just out of curiosity is there a reason not to use short strand fiberglass filler.
  18. J

    Stringer install

    My understanding is to not use pl adhesive or will that be fine so long as there no voids between hull and stringer
  19. J

    Stringer install

    The stringer will crack or the hull? I will use cabosil
  20. J

    Stringer install

    Right o thanks for the input
Top