Search results

  1. Bt Doctur

    Twin Solex pa44 1, volvo penta Aq151B

    if your interested in those cabs I think I have 2 of them from a inline 6 PM me if interested
  2. Bt Doctur

    Pressure test Alpha 1 Gen 2 - do I need to block something

    most llikely the noise is from the seal under the water pump or the shift shaft seal.
  3. Bt Doctur

    Eng acts like safety kill switch is engaged.

    If you mean it will run if you hold the key to start and stop when you release the key, you missing coil voltage when you release the key to the run position. If you have a coil you can access easily run a wire from the + battery to the + side of the coil for testing
  4. Bt Doctur

    cant find correct drive damper plate for my 190 DP

    check the number of splines and see if a Ford clutch has the same number of splines Most engines use a modified clutch plate without the fiber pads
  5. Bt Doctur

    Shift cut out switch problem

    Worst case is wiring it directly to the neg side of the coil if the ground signal is defective inside the ecm
  6. Bt Doctur

    I need the part number for oil pressure sensor

    if a "sender" verify the ohms and check if a mercruiser one is the same rating my be a bit cheaper . check other companies gauges also
  7. Bt Doctur

    Volvo gimbal bearing removal

    believe you dont have a traditional gimbal bearing there you have 2 bearings .one inner and 1 outer look up volvo PDS search Volvo Penta PDS and bearing woes!!
  8. Bt Doctur

    Distributor Shaft Seal Replacement

    unless your getting oil contamination inside the dist, why do you need to replace the seal?
  9. Bt Doctur

    1985 MerCruiser 190

    the stator supplies about 40 volts AC to the regulator ,its there its rectified to DC voltage and regulated
  10. Bt Doctur

    Mercruiser 5.7 with V6-14 TB IV module??

    If it ran before you worked on it then review how you installed the dist. Is the engine set for number 1 cyl on its compression stroke. On comp stroke, set timing indicator to "0" deg on the balancer. install dist with rotor facing to number 1 on the dist cap,then install dist
  11. Bt Doctur

    Sea Water Pump Cover - Question

    in some cases its the front seal that is leaking
  12. Bt Doctur

    Question about 90 amp fuse on starter

    instead of paying and excessive amount for that 90A you can also use the Maxi-Fuse type for the alt protection the 50A one covers everything else
  13. Bt Doctur

    Dissembling a Mercury alpha 1 SE drive

    the lower gears never grind down they just break. Pull the top cap and see if the teeth are missing on the upper gears there first.
  14. Bt Doctur

    Mercruiser 215E

    you may be able to convert to a mechanical shift instead of the electric one
  15. Bt Doctur

    Alpha 1 Gen 2 seal location

    you install it in the upper cover cap, then install the cap.
  16. Bt Doctur

    Where can this water be coming from?

    I agree, cracked block or a core plug.
  17. Bt Doctur

    Temperature Sender?

    This is a better option instead of the Y fitting that gets clogged up just add the bushing for the blue plug in the straight section not the 90. Easier to insert a wire/rod to insure block draining, knock sensor in the 90 end
  18. Bt Doctur

    Water leak into bilge

    you dont list an engine but if a V motor ,there are 2 core plugs on each side of the block near the bottom
Top