Search results

  1. F

    Johnson Power Trim Fluid Help Needed

    I have a 1985 Johnson 200 hp outboard that has been stored for about a year. My power trim motor works good in the up and down positions but the engine does not move. I can pick it up by hand but the cylinder will not move when the trim motor is running. Can I add fluid?? If so, does the motor...
  2. F

    Suzuki dt55 trembles, lacks power, help

    1989 DT55HP stored for 2 years. Carbs were varnished up so I removed and cleaned with carb cleaner. Ran good in water for 15 minutes, then water sensor went out. I replaced the water sensor and oil sensor. Now, starts easily and idles good, but when accelerating it trembles and lacks power. It...
  3. F

    1991 DT55 Oil Injection Advice Needed...

    This engine set for 2 years and I cleaned the carbs and it started right up. I got 3 short beeps at full throttle, when I back off the throttle the beep stopped, but it had full power. I went home and cleaned the oil injection system, then it beeped loud by just turning the key in.Now it doesn't...
  4. F

    Suzuki DT 55 Oil sensor advice needed.

    I have a 1991 DT55 that sat for two years. I removed and cleaned carbs and it ran good until full throttle then it would loose power and beep. I cleaned what I thought was the oil flow sensor and now it runs rough and lacks power. All cylinders are firing but it seem something is not allowing it...
  5. F

    Is my engine too small ????

    I have a 16ft fiberglass Quachita boat that came with a 50hp evinrude and steering. I have removed the 50hp and steering and I have an 18hp johnson tiller handle I want to use. Is this engine too small?? Will it push the boat along ok ??? Opinions appreciated.
  6. F

    18hp on 16ft fiberglass Quachita ????

    I have a 16ft fiberglass Quachita boat that came with a 50hp evinrude and steering. I have removed the 50hp and steering and I have an 18hp johnson tiller handle I want to use. Is this engine too small ?? Will it push the boat along ok ??? Opinions appreciated.
  7. F

    Mechanical Advice Needed......

    1987 Mercury 6hp stuck in neutral. The lower shift rod will not move. How can this be freed so that it will shift?? Thanks.
  8. F

    Stuck, advice needed

    1987 Mercury 6hp stuck in neutral. The lower shift rod will not move. How can this be freed so that it will shift?? Thanks.
  9. F

    1987 mercury 6hp help needed

    I have a 1987 mercury 6hp tiller handle control that is stuck in neutral. The linkage attached to the lower shifter will not move. How can this be repaired and what steps need to be taken. Thanks
View older results
Top