Search results

  1. B

    diagrams for bleeder lines on 89 mariner 150 outboard

    i need the diagram for bleeder lines for q 89 mariner 150 im rebuilding thank you if any on can help
  2. B

    Runs, great wont idle in nuetral

    my 89 150 mariner starts right up in fast idle and when shifted into gear it idles great and runs great, but when you slow down and shift into neutral it usually dies sometimes as if you turned the key off, but it will start right back up in fast idle. It will idle around in gear but when you...
  3. B

    stator A34 or A35 ?

    can anyone tell me the difference between a 398 5454 A34 stator and a 35,and will they replace each other. thank you will they both work on a 89 mariner 150?
  4. B

    adjusting the linkage

    i recently bought an 89 reinell outboard with a 4,3 cobra engine. the person i got i from had removed the linkages and got them all messed up if you set it like you would an outboard you get either forward or reverse, and if you get both it is very rough and it grinds going in i was wonder if...
  5. B

    linkage control arm???

    my son just bought a 89 reinell inboard the control arm on the motor that controls the throttle and the linkage is broken i would like to know what this is called and where to get another one thank you
  6. B

    linkage control arm????

    my son just bought an 89 rienell inboard, and the linkage arm for the throttle and transmission on the side of the motor is broken. i would like to know what its called and where would be a good place to get one.
  7. B

    correct plugs

    i have a 87 mariner 150 i would like to know what is the correct plug and if brands and cross matching matters such as auto lite champion etc thanks lonnie
  8. B

    indentification and max rpm for 150 mariner

    i have a 89 mariner 150 mag or so all my paper work says. everthing is original from the original owner and the bill of sell and all the paper work says its a 150 mag. the serial no is OB117411. and most guys i talk too around here say that they cant find that serial no or that its a plain 150...
  9. B

    gaskets for 150 mariner

    can anyone tell me where i can get a gasket kit for the power head 150 mairner
  10. B

    2 engine batteries???

    i would like to run 2 engine batteries on my boat because of the power drain night fishing with lights and aerator hooked up to still be 12 volts will this hurt anything stator, rectifer etc thanks
  11. B

    what would burn out a stator on a 87 150 marn within minutes

    i posted a couple weeks ago about idle probs with the 87 150 marn a got some good info on the problem, basicly the consensus was carb prob i rebuilt all of them followed all of the advice but it didnt help checking with an ohm meter i found the stator to be bad i changed it and it idled GREAT...
  12. B

    still having idling probs

    my 87 marnier150 mag is still having low end starting and idling probs when it starts in fast idle on high will only tach about 2000 normally it would race way up sometimes it will start and idle for a few minutes then it sounds like it loses power and will slowly die once it is started and...
  13. B

    150 marnier spark plugs

    does any body know the correct spark plug for a 87 marnier 150 magnum with carbs
  14. B

    78 marnier 150 starting and idle probs

    i have an 87 marnier that starts cold pretty good but takes a long time before it will idle in gear if you get right on it it runs great but when you stop for a while its starts and dies unless you through it into gear or it will kick out the starter and when it idles it idles at 1100 rpms...
  15. B

    87 marnier150 m idle problems

    my outboard usually starts pretty good cold but it dies when you put it in gear unless you get on it [ not good in tourny's ] after it warms up it idles in gear ok but is hard to start and the starter will sometimes kick back and sometimes when you run to the ramp to load it wont idle it...
View older results
Top