Search results

  1. 04fxdwgi25

    Help with new Lenco Trim Tab Switch

    I'm confused. From the pictures, it does not look like switches are wired exactly the same.
  2. 04fxdwgi25

    Question about tying in a new trim/tilt switch

    If you supply a picture of the old switch, maybe it can be matched up. Give them a call. Switch may be one of the universal ones on Amazon (who also sells the Vivor control). Here is the vendors website link for that control...
  3. 04fxdwgi25

    Should I be worried

    That trailer is too small for that boat. Not a fan of the bunks overhanging end of trailer like that. Many aluminum trailers are like that and think it is basically a cost saving move. 2x6 is cheaper than aluminum. Prefer having the trailer frame and supports under the end of the bunk /...
  4. 04fxdwgi25

    I/O taking on water while sitting not moving

    Well, maybe if he finds the leak and can supply accurate info, only then can we assist with some how to answers to assist. Unknown location = unknown problem or fix.
  5. 04fxdwgi25

    Need help with shifter quicksilver

    Check your mail at the top of the page........
  6. 04fxdwgi25

    Need help with shifter quicksilver

    I have the manual for all the Mercontrols, if you want it. Too big to post here @24 meg PM sent Per the manual, shifter should be in neutral to reassemble.
  7. 04fxdwgi25

    trouble getting reverse.

    That red hose is home brew rig for flushing the engine / cooling system or running engine while boat is out of the water.. Has nothing to do with the clear box. Look closely at the plastic box and you can see a Rule Pump (red cover) through the semi clear top. That is the grey water pump...
  8. 04fxdwgi25

    Best carpet for trailer bunks

    I bet any outdoor carpet would work. Bought 16" wide rolls at Home Depot (was super cheap) when I did new bunks. Lasted years.
  9. 04fxdwgi25

    How to bleed trailer brakes

    On last tandem trailer, bought a new fill cap for the actuator. Drilled an tapped a 1/4" NPT hole in top of the old one and added a hose that I connected to a 1 gallon garden sprayer with DOT 3 brake fluid in it and pumped up sprayer a bit. Bled brake calipers till I saw clean fluid. Done in 20...
  10. 04fxdwgi25

    I/O taking on water while sitting not moving

    Agree with Scott. Looks like a rubber cap with a clamp on it that has aged and split right at the top. Take it off and try to match it up at the hardware or auto parts store.. If you can't find a match, maybe even put a short section of hose on with a plug in it. Might be the cheapest fix you...
  11. 04fxdwgi25

    trouble getting reverse.

    Not quite sure what you are explaining, here.
  12. 04fxdwgi25

    How to bleed trailer brakes

    Manuals can be found on the internet easily. Just need the trailer coupler make and model. That is usually stamped on the coupler itself or the coupler housing.
  13. 04fxdwgi25

    2010 Ford E250 Weight Towing Question

    You show tow weight as 3,500 lbs. Add another 500 for stuff on the toon, like water, fuel, gear, etc. You show tow capability is 6,000lbs. Good to go. Just make sure the trailer has a good braking system. On the side note, this max towing weight will be reduced by the amount of lbs you add on a...
  14. 04fxdwgi25

    trouble getting reverse.

    That box is the grey water drain / pump out for shower and/or sinks. Grey water is non-potable water / everything except sewage I fear the grey tank you are referring to is the sewage tank for the head (toilet). That aint grew water........
  15. 04fxdwgi25

    Alpha one gen 1 steering arm slop

    That arm is aluminum, but since it is loose, I would suspect that it is wollowed out on the steel pin a bit and may not tighten.
  16. 04fxdwgi25

    trouble getting reverse.

    You do have closed cooling. That tank with the radiator cap is the heat exchanger. Normally filed with automotive type coolant / anti freeze. That box in the bilges is probably a shower / sink drain tank that uses a bilge type pump inside the tank to pump it out.
  17. 04fxdwgi25

    Alpha one gen 1 steering arm slop

    The nut on top holds the steering pin and adjusts the clearance on the lower pin bushing. The steering arm is then clamped onto the steering pin by a pinch bolt that clamps / squishes the arm to the pin. That pinch bolt / nut are on the sides. There are kits to gain access to the nut from...
  18. 04fxdwgi25

    trouble getting reverse.

    Square opague tank - Dark green oil = Drive unit lube oil reservoir. Power steering fluid would be red or almost clear, depending on what oil was put in.
  19. 04fxdwgi25

    bad interuptor switch

    Deffinately a Mercruiser Alpha possibility It is usually the adjustment of the cables and / or a bad lower shift cable.
  20. 04fxdwgi25

    Steering cable issue

    If I operate the actuator manually the outdrive swings right and left, quickly and without any sense of lack of pressure. If I hold it in full lock for a second or two it tries to stall the motor. Would those things happen if the pressure was low? Following this, myself, as have seen this a few...
Top