Search results

  1. C

    1998 115 (E115SLECM) VRO leaking fuel

    tdon'T assume anything check out the utubes and dig in... at worst you can pre-mix.
  2. C

    2018 E-TEC 25 hp Not Running Well

    very simply unplug the connector take B+ and neg from the battery and apply it to the bue and green wires to the trim motor wires in the connector it will or should go up or down ... then just reverse the polarity and the motor should reverse direction . stale gas is terrible for...
  3. C

    2018 E-TEC 25 hp Not Running Well

    Some like them young some like them old ...:) I am running oldies to :) love them all. that 9.5 is 60 years younger !! the Mercs.. probably 50 years
  4. C

    2018 E-TEC 25 hp Not Running Well

    see typical wire diag for t&T motor connection and access to connector from relay box
  5. C

    2018 E-TEC 25 hp Not Running Well

    tilt motor wise 2 wires feed to motor.. usually blue and green if the motor works one way it should normal work the other way if...polarity gets reversed by the relay assembly. hearing relay clicks is good, seeing volts is fine but if relays do not pass a high current load to the the...
  6. C

    lots of 502 504 bad gateway and timeouts ???

    Why'd you put this in J & E outboards.....? because it is all I use on IBOATS.... and the few replies are already telling me something goofy is happening on the Internet and my PC is fine. ;-) must be Musk's fault :-)
  7. C

    lots of 502 504 bad gateway and timeouts ???

    Since last week I seem to be getting a lot of 502- 504 Net connection failures to IBOATS ( and only with IBOATS site) anybody else ?
  8. C

    63' Johnson 10hp Throttle issues

    to service oldies get this book ..cheap for $20 450 pages + some parts may still be ordered from good dealers if not NLA try EBAY https://watercraftmanuals.com/outboard/johnson/manuals/johnson-302231.htm
  9. C

    Fuel for older Evinrude/ Johnson

    yes run 24/1 twc3 oil fuel mix nothing wrong with 87 octane 10% fuel use fuel saver additive . I always store fully fuelled and carbs full during winter storage. never have problems.. you can run 16/1 in 1950s OBs and older 50/1 was pretty well the norm mid 1960s and up
  10. C

    2018 E-TEC 25 hp Not Running Well

  11. C

    2018 E-TEC 25 hp Not Running Well

    first thing is not to loose confidence tilt down failures are usually bad down switch or down signal to the relay box or bad relay box itself. see wiring diagram in the manual & get yourself the proper diagnostic software and pull out the report you may be in SAFE mode limiting...
  12. C

    Evinrude 9.9 HP Model # 10924B

    feeling for the crankcase pressure pulse is with the fuel pump removed ! and someone pulling the starter rope for you. if you fell no pressure pulse out of the engine side fuel pump pulse port the pump will never work . can you take this kicker in a good shop ?
  13. C

    1996 Johnson 60hp 2 stroke not getting to full speed at random times

    either the coil is not firing or being fired or the sparks do not reach the plug do a good ohms test to grd on the plug wire(es) and compare things. things break or corrode
  14. C

    Evinrude 9.9 HP Model # 10924B

    fuel tank above the carb... connecting a battery involves basic knowledge of outboard electrical cct suggest you red up on the subject battery must be connected to the large red and black cable red is + then you need to activate the solenoid that transfers battery power to the...
  15. C

    Evinrude 9.9 HP Model # 10924B

    btw you have electric start ... why not hook up a battery and get it going. very basic circuitry find the solenoid and follow the small control wire to the start switch ! basic for 1984 should be similar to yours even if earlier model. yellow red to solenoid should activate the...
  16. C

    Evinrude 9.9 HP Model # 10924B

    I restarted and keep pumping the bulb than it keeps running. hand pump it again and make certain the tank is ABOVE the engine try to start it... if it runs the pump is faulty install a new one . (up to you $$ ) The only reason the pump would not work is that the crankcase pressure pulse on...
  17. C

    Evinrude 9.9 HP Model # 10924B

    Did not work meaning what..... blow test failed ?? Why don't you try a new pump. That kicker looks real clean and giving up on it would be a shame. Reassembly (orientation of parts) is confusing the first time around.
  18. C

    1990 Evinrude 9.9/15 still starting rough

    so what are you saying... problem fixed ?
  19. C

    1990 Evinrude 9.9/15 still starting rough

    Leroy's has lots of info on the 9.8-15 you should read starting with this one....see HARD STARTING https://www.leeroysramblings.com/Johnson%209.9_15.htm see all his topics https://www.leeroysramblings.com/Outboard%20Motor%20Related/OMC%20outboard%20related%20articles.html
  20. C

    1990 Evinrude 9.9/15 still starting rough

    try openning up the LS needle 1/4 CCW . Starting an engine is done by pulling fuel from the LS circuit of the carb and make certain that little tube is set properly
Top