Search results

  1. alldodge

    mercruiser 454 MPI Horizon stalling

    Vacuum should be around 14 in Hg but boats are normally lower, never have figured that one out Timing setting should be close to 1800 rpm
  2. alldodge

    farymann 18W ( generator engine ) white smoke

    With a diesel my guess it's unburt fuel, because if it was water there would expect to see bent con rods
  3. alldodge

    Hinge pin

    Thanks was thinking Gen 2 and being a 2000 it is The part is item 30 in LINK for use with trim sensors in addition to the fiber
  4. alldodge

    mercruiser 454 MPI Horizon stalling

    A Horizon should be manual 23 The IAC moving in/out whit initial key on is one test, but may still be an IAC issue The 454 should not have adjustable rockers, it's torque to 40 ft lb Need to set timing Check vacuum
  5. alldodge

    Hinge pin

    There should be a fiber washer on each side between gimbal ring and bell housing What year is the boat?
  6. alldodge

    MerCruiser MCM 165 Trim Sender Wire

    All good, will try and explain until you understand Your drive does not have the senders mounted which means your drive does not have the capability for the trim gauge. Even if you have a brown/white wire at the helm, the option for it can not be added without replacing the transom assembly...
  7. alldodge

    MerCruiser MCM 165 Trim Sender Wire

    The wire goes to the starboard side gimbal ring trim sender. Look for the 4 black wires coming inside the boat from the top of the transom assembly. Two go to trim limit and the other two are go the sender. The black wires connect to other wires with bullet connectors
  8. alldodge

    Lost Remote Control

    Welcome Search for "winch remote control replacement" , there are several kits out there
  9. alldodge

    Boats from work.

    Can see several of those on Offshore only forum
  10. alldodge

    LiFePO Batteries ???

    Always build your pole barns with a 14ft door
  11. alldodge

    NO insects or spring birds this year.

    For the last month a Blue bird picks on our bedroom door starting around 5:30AM. The bird house is close by and there is a nest but have not seen eggs or the female. I'm thinking the female was killed somehow. We usually get to 2 sets of Blues every year
  12. alldodge

    No current to purple alternator excite wire

    From the key the wire has a splice and one lead goes to the ALT and the other goes to the engine to MPI connector (item b lower right corner)
  13. alldodge

    No current to purple alternator excite wire

    The purple wire comes from the key switch, there is no diode You could run another wire from the + side of the coil over to it
  14. alldodge

    Trail camera issues fixed, now pics from them ...

    Could just change the title on this one
  15. alldodge

    Installing the New Version of the Bell Crank With the Grease port

    Hey @Lou C or @Scott Danforth have any ideas?
  16. alldodge

    MerCruiser MCM 165 Trim Sender Wire

    Welcome When the trim sender first started it uses a Brown/White wire, and still does today
  17. alldodge

    Left stranded on ICW - '07 5.0 GXI Safety Lanyard circuit?

    Your first time it would not start and giving it more throttle it started. Giving it more throttle does not allow it to start this time?
  18. alldodge

    Cracked transom back plate

    Your problem is the inside surface of the transom is not flat Remove plate and use a steel straight edge to find the problem areas
  19. alldodge

    Bravo 3 steering sensor and Trim sender and trim wires, DTS adaptor cables?

    The manual number listed above is the install manual, and I also have it. Page 4D-21 shows the 14 pin motor connector and other connectors like the 10 gauge connector for analog gauges. 16 pin on 4D-18
  20. alldodge

    Bravo 3 steering sensor and Trim sender and trim wires, DTS adaptor cables?

    Looks like you need manual 8M0099748 The helm 16 pin harness is for DTS and 14 pin is for mechanical The motor uses a 14 pin harness is different. The communications between the helm and motor is done via CAN buss
Top