Search results

  1. nola mike

    MC-1 Drive Dog failure?

    I've always used permatex without issue.
  2. nola mike

    MC-1 Drive Dog failure?

    You got a lot going on. --Input shaft seal is responsible for the oil in the bellows. Where is the water coming from in the bellows? That could possibly be the reason for the water in the oil as well --i don't think you need to set preload on an mc1, someone correct my if I'm wrong --as...
  3. nola mike

    Broken console to control shift cable

    Shift interrupt won't trigger if you're only shifting using the lower cable.
  4. nola mike

    Gen 1 305 swap with gen 2 4.3

    Ah, true. Was mostly responding to scott's post. If you're dropping it in the starter is going with it. The 4.3 flywheel IIRC is not matched to the motor, ie the motor is internally balanced. Not sure about the 5.0? I think I was also thinking about the flywheel/coupler difficulties that can...
  5. nola mike

    New Winch or Winch Strap?

    IIRC from his shenanigans he does, and is why the boat isn't on the highway :)
  6. nola mike

    1986 Winner Quest 186

    65 gallons seems big. If you want to get an accurate answer you might need to do some tank draining (not that hard) or depending on how much tank is visible you can do some rough measurements.
  7. nola mike

    Gen 1 305 swap with gen 2 4.3

    Flywheels wouldn't swap over?
  8. nola mike

    Gauges recommendation

    Another super helpful comment. Keep them coming.
  9. nola mike

    Vapor lock or something else?

    Winter blended fuels vaporize easier
  10. nola mike

    Gauges recommendation

    Alright, sounds like you officially have a bad volt gauge. Fuel gauge sounds OK, wouldn't worry about where it settles key off. Last is the tach. "Wonky" might need a better description. First step is cleaning the connection at the coil (you said already clean at the helm) or disconnect the...
  11. nola mike

    Boat Died on the Charles River (Massachusetts) - Had to Self Rescue!

    I took a trip up to DC with my buddy on his boat. He assured me that the tank was full. He also said that the fuel gauge was broken. I brought a Jerry can just in case. Boat broke down several times before I pulled the fuel filter and saw that it was dry. Apparently he knew that the tank was...
  12. nola mike

    Gauges recommendation

    What exactly is the fuel gauge doing? So engine running you get 14v on your voltmeter with the leads connected, but 16 volts on your gauge? Next test: Ground the sender wire from your fuel gauge. Should peg full. Disconnect sender wire. Should read empty.
  13. nola mike

    Boat Died on the Charles River (Massachusetts) - Had to Self Rescue!

    Wow, glad it worked out. You did so many stupid things that the stars must have been in your favor (no offense, much of my life is based on questionable decisions). I grew up a town over from you...which lake were you on?
  14. nola mike

    MC-1 Gimbal bearing snap ring.

    Depends on where you're getting stuck. I've found that the key is to get the drive perfectly parallel to the bellhousing. Drive sits on the ground, lift/lower trailer as necessary. How do you not have a grease zerk on your drive? I can't imagine they put in greaseable bearings without a way to...
  15. nola mike

    4.3 v6 Timing suggestion

    Just thinking about this, does anyone know of an aftermarket knock sensor kit? Seems pretty easy to use a stock sensor with a buzzer or something on it... It would be cool to actually be able to dial in timing and fuel mixture based on something better than feelings.
  16. nola mike

    4.3 lt Mercriser Cranks But will not start on idle and will not idle.

    I assume OP wants to use the boat after the engine has warmed up in addition to having it start.
  17. nola mike

    4.3 lt Mercriser Cranks But will not start on idle and will not idle.

    You're smarter than me. I was going to suggest holding your hand over the intake to see if it improves things
  18. nola mike

    Won’t Start in the Water

    Blows my mind that people don't do this. I always assume my engine won't start LOL. My neighbor had her boat on the lift (brackish water) all winter. Wanted me to help her pull it. Short story, she didn't even try to start it before hooking up the trailer and heading to the ramp. Just assumed it...
  19. nola mike

    Mercruiser 4.3 reverse engagement issue

    It's the lower cable that gets the 6" adjustment....
  20. nola mike

    I Got Me a Mercury !!!

    Would you stop it with that talk?
Top