Search results

  1. stresspoint

    Help a little old lady with her little old mercruiser 120 wiring?

    you're welcome !.
  2. stresspoint

    Help a little old lady with her little old mercruiser 120 wiring?

    here you go :)
  3. stresspoint

    How to install a hull lift point?

    i lift boats off the trailer all the time with the engine lifting points for the rear , use the crane to get the back end a few inches off the trailer, wheel the trailer far enough to get the trolly located under the boat , bring the crane to the front and lift from the eye bolt drag the trailer...
  4. stresspoint

    Spark & Fuel but no go?

    you have to take the FW off to inspect the key. have you confirmed the orientation of the wires going to the coils from the ecu/ switch box/ cdi / ignition module or whatever names people call the unit that makes sparks happen are correct
  5. stresspoint

    tilt motor removal?

    hey no argument here , i have a work shop full of tools 1/2 hour job on a bad day :).. hey OP , looking at the wiring loom going to the trim motor it looks like it may have already been replaced at some point , might be worth the time it takes to un peel all that tape and check the connections...
  6. stresspoint

    tilt motor removal?

    easier way ???????????? , """from experience"" on an old motor that is not the easy way . ? are you forgetting the tilt shaft nut , probably rusted to the shaft ,OP finding a 1 1/4 socket or hacking it with stilsons or spme sort of channel locks steering , cable tilt pin realignment if it comes...
  7. stresspoint

    Johnson 70EL76D Looper Terminal Block Wiring

    ahhh , remember when :) , ya , i agree the old 2 smokers were reliable and would be almost dead before they would stop . i had forgotten how simple things were back in the 70s when OPs motor was popular , hence why i posted that something should have stopped the motor with no over temp warning...
  8. stresspoint

    tilt motor removal?

    its a simple job to remove the motor " however " OP has stated he does not have access to lifting equipment , so it will need to be done how we did my mates motor in the paddock. put a jack under the skeg to support the motor ( a block of wood will do the job) unbolt and remove the 2 top engine...
  9. stresspoint

    tilt motor removal?

    bolts snapping from corrosion .getting the broken bits out with a torch requires the motor to be removed
  10. stresspoint

    Johnson 70EL76D Looper Terminal Block Wiring

    so not like other motors where the motor either goes into limp or shuts down if an over heat happens. must be I'm so used to working on later high tech motors iv forgotten about how privative things were :) back in the day. learn something new each day, what would we do without the internet?.
  11. stresspoint

    Johnson 70EL76D Looper Terminal Block Wiring

    my bad i was not concise enough !. power pack , cut out mode .
  12. stresspoint

    Johnson 70EL76D Looper Terminal Block Wiring

    i don't think any one is scolding you , there are knowledgeable people here on this forum that can help you only when you give information relative to the issue you are facing and what steps have already taken to rectified the issue.. it is possible that the over temp warning "" not working ""...
  13. stresspoint

    Johnson 70EL76D Looper Terminal Block Wiring

    lets start by taking a step back . the motor was running but had a slight hesitation that got worse after the boat sat, which in turn caused it to not be able to plane out . ? did you see any improvement once you put the new parts IE: plugs , CDI , coils ,etc. ? , what made the "mechanic '...
  14. stresspoint

    tilt motor removal?

    i hate to be the bearer of bad news , the motor has to come back off the hull to get that screw. if you are good with ratchet straps and a trolly jack you will be able to get the motor unbolted and leaned back far enough get access to the screw with extension bars and wobble joints. we did one...
  15. stresspoint

    Canceling DISH account....

    call up the number to set up a new account then when you get through tell them its to cancel the one you have ,telcos love new customers :).
  16. stresspoint

    Low Compression, Low $ Advice

    easier said than done with an outboard :).
  17. stresspoint

    Low Compression, Low $ Advice

    run it like you stole it , chances are a good blast will bring up the numbers. IMHO that motor will probably live as long as the boat. funny thing about compression numbers and how people get to thinking a motor is dead because of a number that is 10 or 15 PSI low on a cylinder. news flash >>>...
  18. stresspoint

    axle repair sleeve question

    you should not need to use any form of glue or what not on a 'speedy sleeve' if you have the correct one. also as posted ' never use heat ' to make the sleeve go on. if done correctly , the sleeve should slide strait in place , you can use a small smear of grease to start the process , be sure...
  19. stresspoint

    Mercruiser 6.2 repower/finding an engine

    compression ratio may be a little different but i think the ECU will manage just fine.
  20. stresspoint

    HELP: Rusted bolts on leaf springs

    they are splined in as they are tightened , smash the threaded part with a BFH to push past the splines ,(normally just put the nut on a few threads and smack the thing a few times ) once the bolt is free of the spline , take the weight an push the rest of the way
Top