Search results

  1. J

    Water coming into bilge

    I grabbed a tube sikaflex 291. How about using that bondo or should I grab a certain kind of permaseal
  2. J

    Water coming into bilge

    Now the fact that the inside of drive bellows was dry rules that out...and the exhaust bellows was wet and a bad seal at y pipe allowed water into bilge. Sound a out right?
  3. J

    Water coming into bilge

    Ok thank you I will check all
  4. J

    Water coming into bilge

    That's what it looked like when the engine was still in. I pulled engine and the drive. Ran water with a hose down both exhaust pipes it it was leaking out the bottom. Mine looks different then that pic...2 round holes. 1 big one and has o rings. They were all still in place. Now if running...
  5. J

    Water coming into bilge

    I used red rtv and it isn't really all that stuck so I'm to believe it isn't the right sealant
  6. J

    Water coming into bilge

    The orings were still in place...the roughness is silicon. I'm not sure what you mean about vent.holes
  7. J

    Water coming into bilge

    Here are some pictures of y pipe. I ran water down both pipes and water was going into bilge.
  8. J

    Water coming into bilge

    My suspicion is the top portion of y pipe isn't sealed correctly as the water leak is coming from the top
  9. J

    Water coming into bilge

    Alright...I pulled outdrive and there is water in the exhaust bellows..none in drive bellows...o ring still inplace
  10. J

    Water coming into bilge

    I haven't ran it on muffs yet.still waiting for dizzy. It's leaking below the drive shaft and above y pipe. I haven't pulled drive yet but I guess I will
  11. J

    Water coming into bilge

    I replaced the bellows and also redid the y pipe. I put boat in water and there is a steady stream coming from just above the top y pipe bolt. Any suggestions
  12. J

    Ford 302 flywheel direction

    There was no pin and the flywheel wasn't drilled to fit so it must be good.thanks guys
  13. J

    Ford 302 flywheel direction

    What's concerning me is the weights location relevant to crank type thing
  14. J

    Ford 302 flywheel direction

    Here's how it was put in....flywheel onto studs with the indent portion facing out. Coupler onto studs. There was no key way or line up marks
  15. J

    Ford 302 flywheel direction

    I have since installing new engine if the flywheel was installed the same way it came off. I haven't started it yet as no distributor. I was told by my help that it really doesn't matter. It went on easy so my question now is...does it matter...and if so now what or how to tell without ripping...
  16. J

    Ford 302 exhaust elbow

    I'm in the middle of installing the manifolds right now . So if there on good to go ???
  17. J

    Ford 302 exhaust elbow

    The new engine is in and mounted.
  18. J

    Ford 302 exhaust elbow

    I will add that my outdrive is in and all sealed as in bellows and gaskets
  19. J

    Ford 302 exhaust elbow

    My engine isn't ready to use. I have not hooked up my exhaust manifolds or elbows. Y pipe has new flappers. Is it possible to use boat with the kicker or will my boat sink
  20. J

    2001 yamaha 9.9

    Here is pic...it's the top outlet I cannot blow air through
View older results
Top