Search results

  1. alldodge

    Setting Timing on a 2002 VP5.7GXI-A

    Correct
  2. alldodge

    Setting Timing on a 2002 VP5.7GXI-A

    EFI and MPI motors when not in base timing mode are constantly changing, most times not much but still moving
  3. alldodge

    Single point drain

    Not what you want to here but there are a few variables. With open cooling and single point drain you should have a blue plug on the thermostat housing. Either that or will have a small air pump mounted on it. The drive comes up as a A G2, so there is no worries with the raw water pump The...
  4. alldodge

    Tell Tail Issues after 300 hr Service

    I'm puzzled with you, hope one of the better OB guys can advise Water pressure should increase as rpms go up, but with it being random of peeing it's like maybe sucking some air
  5. alldodge

    Tell Tail Issues after 300 hr Service

    Does motor have smartcraft or other means of telling water pressure?
  6. alldodge

    Single point drain

    In most cases there is also plugs on the raw water pump or there is air valves What is your motor serial number?
  7. alldodge

    Single acting Hydraulic Cylinder Woods Batwing

    Removed pipe plug, and when cylinder was retracted it belched out some oil. Going to drill maybe a 1/16 hole in the plug for now. I see they make breather plugs and may change later. Also need to look into cylinder rebuild kit
  8. alldodge

    Setting Timing on a 2002 VP5.7GXI-A

    Maybe but may also cause a trouble code with the other connector removed and may not even start. Pic is blurry but note the connector top center
  9. alldodge

    Setting Timing on a 2002 VP5.7GXI-A

    That is correct how timing is done using an advance timing light and not having a ECM. You may be able to do it with a ECM but I cannot say for sure. Your motor does have the connector it's just has not been found yet
  10. alldodge

    Painting the bottom of a yacht

    Yes
  11. alldodge

    2005 3.0l Mercruiser

    Kind of odd from them to fail that soon, they normally last for the life of the boat. A 3.0 just doesn't produce that much torque Does the alignment bar go in easy? Have you tried tightening the bolts 38 ft-lb?
  12. alldodge

    NOCO LifeP04 in lawn mower

    No I haven't but can give it a look.
  13. alldodge

    Single acting Hydraulic Cylinder Woods Batwing

    Was thinking that also, thanks Went out with a ratchet wrench earlier to pull plug on bottom of cylinder but couldn't budge it, going to need a breaker bar I think
  14. alldodge

    Single acting Hydraulic Cylinder Woods Batwing

    Thanks, but that's not it
  15. alldodge

    NOCO LifeP04 in lawn mower

    It's a zero turn, no lights or anything else, not even a hour meter
  16. alldodge

    NOCO LifeP04 in lawn mower

    Just checked the Noco Bat and it reads 13.2V so when it read 2V must have been in protection mode
  17. alldodge

    Single acting Hydraulic Cylinder Woods Batwing

    Have a Woods Batwing finish mower model 9204RD-2 Issue: L/R wings will not move enough to lock into transport latches without manual help It use to be only the left wouldn't latch without help but now it's both. Noticed today that the piston on the ring has not retracted and has at least 1...
  18. alldodge

    NOCO LifeP04 in lawn mower

    Mine is a 20hp Honda, forget model but it's about 25 years old
  19. alldodge

    Boat won't turn right at speed

    Good news, thanks for the update
  20. alldodge

    Outdrive tight after steering pin and lower bushings replaced

    Your probably fine. I would not worry about the PS because it's designed for a whole lot more load then a stiff pivot point
Top