Search results

  1. alldodge

    15 HP Mercury 4-Stroke water in oil

    Need to find where the oil is coming in at, if it's a crack or a gasket. My guess is its just a gasket/seal. Would suggest start taking the motor apart until the issue is found.
  2. alldodge

    Which States/Provinces Enforce Registration Numbers Requirements

    Same as most LEO's will do nothing if your speed exceeds 5 MPH over, and very few will bother with 8 over. My observation, if your on the great lakes or coast line, then do it according to the Reg's. If your inland not many will pay any attention unless your doing something stupid Sorry I...
  3. alldodge

    Which States/Provinces Enforce Registration Numbers Requirements

    Good grief, now your quoting Fed Reg and laws Post 1 Soooo, not every place does enforce to the exact letter of the law
  4. alldodge

    Ignition

    Call around your local auto parts places, might get lucky. Also many times Walmart might have it in the marine area. If they do you should be able to find it online and select the store and it will show if it can be picked up
  5. alldodge

    Ignition

    All good, you can get the entire assembly or just the fuse inside as pic above
  6. alldodge

    Ignition

    Yes, that is the Alternator protection fuse. If its blown then 12V will not pass. The fuse is inside the block. Check continuity from the small bolt to the large tab
  7. alldodge

    Ignition

    Well ya got to start with what are you working on? In your other thread it's probably a 2007 3.0 with AG2 drive. Could use your motor serial number. Going to need a voltmeter. There is a 90 Amp fuse on the starter post, it's square looking and has the fuse inside it
  8. alldodge

    Mercruiser 4.3 injection without any ignition

    Very nice write up, thank you
  9. alldodge

    Support pole for my BP

    Small PVC pipe and bow it under the cover
  10. alldodge

    need starter for chrysler 70hp model 707hf availability

    Check out FB chrysler groups, there are a few of them and many of the guys sell parts
  11. alldodge

    Dean's List gets another motor

    Never did get it to fully prime. Pulled a lifter at end on each side and oil was making it there, but it only made it up 3 push rods on port side. Rotate crank 90* a few times, and other then cold 20w50 oil, don't know.
  12. alldodge

    Mercruiser outdrive oil/liquid leak during winter

    Your leaking on the outside, so start there. By the looks of your boots you may need to replace them also. In any case remove the bell housing to gain access to the hose Look at the inside hose to see if it also needs replacing and then see if there is enough access
  13. alldodge

    Dean's List gets another motor

    Didn't take a pic but motor is done and now its wait till the boat comes out
  14. alldodge

    Mercruiser outdrive oil/liquid leak during winter

    Agree with BT, but being a 1998 it might be brass fitting, but repair is the same
  15. alldodge

    Wiring in kill switch - 2004 Volvo 4.3

    open or closed has not bearing on a kill switch No, wire does not go to ground VP is same as Merc. Find the purple wire coming from the key switch and use the NC contacts when lanyard is installed. When lanyard is pulled it will open the contacts and remove power to the motor thereby killing...
  16. alldodge

    Mercruiser carburetor question

    Doing anything on Muffs means nothing other then it will run Going from 4500 full load to idle can cause many motors to have trouble. Idle is set at 700 RPM and should maintain that under load (idling in the water in gear)
  17. alldodge

    Wiring a kill switch to 85h chrysler magnapower

    Most kill switches work either way, NC or NO, just attach lanyard to the other contacts on the back
  18. alldodge

    Wiring a kill switch to 85h chrysler magnapower

    Then racerone is correct and I was wrong The key places 12V on the coil to start and removes to stop Place normally closed (NC) switch in the Blue wire. When lanyard is pulled it will open the connection and kill the motor
  19. alldodge

    Wiring a kill switch to 85h chrysler magnapower

    How many and what color wires are on the I terminal?
  20. alldodge

    Wiring a kill switch to 85h chrysler magnapower

    Have to agree How do you start and stop the motor now? Here is wiring https://maxrules.com/graphics/force/wiring/Chry70_135Mag2.gif
Top