Search results

  1. alldodge

    Adding a Temperature Gauge

    This is a woops on my part, thought you started 2 threads of same post but you posted to an old thread and then this one Gauge is pretty simple, Connect sender to sender connection on gauge. Connect 12V and ground to gauge connections and its done. Do use a 12V connection that is switched ON...
  2. alldodge

    Low operating temperature in a Mercury 90

    Welcome, and note not ok to post same question in 2 areas Gauge is pretty simple, Connect sender to sender connection on gauge. Connect 12V and ground to gauge connections and its done. Do use a 12V connection that is switched ON when key is turned to ON
  3. alldodge

    Start and run Mercury 5.7 on stand

    The ECM applies grounds to relay coils to energize them, and this isn't happening. If it was mine I would open the ECM (drill rivets out if needed) and see if it needs to be dried out. If all good then have it tested
  4. alldodge

    Start and run Mercury 5.7 on stand

    Submerged that helps I would replace the relays, but could swap them to see if things change. Local auto parts will have the relays that will work the same, just may not look the same. Could also remove the cover off the ECM to see if it needs drying out If it was salt need to do as Scott...
  5. alldodge

    Start and run Mercury 5.7 on stand

    ok, Check fuses, there is at least 3 of them When power is applied to pin C does the MPR (main power relay) click? When power is applied is there 12V at the fuel pump? Note, power energizes the MPR which powers up the ECM. The ECM then applies a ground to the FPR which would turn the pump ON...
  6. alldodge

    Start and run Mercury 5.7 on stand

    Do you have pin B grounded?
  7. alldodge

    Dean's List gets another motor

    Getting FelPro 17046 OSO folks say its good for STD to .060, has 4.370 bore
  8. alldodge

    Dean's List gets another motor

    What I find with 454 there are cut outs for the valves, the 502 doesn't have them
  9. alldodge

    Dean's List gets another motor

    Does appear the difference in 3601 (6 point) and 3701 (12 point) but it doesn't list the lengths Which Felpro head set did you find?
  10. alldodge

    Dean's List gets another motor

    There 088 GM cast heads Also came across the head gasket issue but think were good with it. 502 STD bore 4.446 454 bored .060 over 4.310 The first 502 head gasket set picked up was larger then the bore of the 454.
  11. alldodge

    Dean's List gets another motor

    Bolts and rectangular
  12. alldodge

    Dean's List gets another motor

    Never thought head bolts would be such an issue. Mistake 1 was to use a 454 as the baseline for the head, wrong. Find a ARP kit 3607 which comes with 3 different lengths and 8 are 5 inches which are to long. Original bolts removed from head were 24 each at 4.187 and 8 at 2.187, with speck...
  13. alldodge

    Alarm and then limp mode 2015 Mercury 50 hp 4 stroke

    If this is a EFI motor look for another sensor on the head. Could be the temp sensor is the issue, otherwise need a scan
  14. alldodge

    "Christmas staff fund charge" on my marina bill?

    Malinials
  15. alldodge

    Alarm and then limp mode 2015 Mercury 50 hp 4 stroke

    If that's the ECM temp sensor then that's what's sounding the alarm, otherwise need to scan the motor to find out what is causing alarm
  16. alldodge

    "Christmas staff fund charge" on my marina bill?

    My marina hasn't started this kind of thing "yet", but they did start charging 5% if a credit card is used. Marina gets charged around 3% and they charge 5. The ruff point is if your paying cash/check you have to ask them to remove it
  17. alldodge

    Mercruiser Engine ID - No serial number

    Going to need to advise further One of the parts listed is a Sierra "aftermarket" part. Note that BAM and Mercury Marine do not list the E choke, only the dash pot Not saying your not right, but if you use Mercury parts break down its not listed.
  18. alldodge

    Winterization Question

    Not counting all the Green AF going in the water or down the sewer can kill things
  19. alldodge

    Mercruiser Engine ID - No serial number

    Post link
  20. alldodge

    Mercruiser Engine ID - No serial number

    Don't know what to say, looking thru BAM parts list I'm not finding an electric
Top