Search results

  1. alldodge

    Mercruiser Engine ID - No serial number

    EST started in about 95 for the 3.0 The 3.0 didn't start using the electric choke til just before they went to TKS Find the flame arrestor number was used on the 470. Boat probably had a 470 and was replaced with the 3.0
  2. alldodge

    Mercruiser Engine ID - No serial number

    Made another search with a must have 15397A4 and found a carb listing in France on Rock Auto, but still no year. Could be the boat was once over seas
  3. alldodge

    Mercruiser Engine ID - No serial number

    I'm not able to find the carb number, you sure that's the number?
  4. alldodge

    Admiral's New shower

    The bath about did me in. Currently waiting on cabinets and need to trim out the window, but basically done
  5. alldodge

    496mag no start issue.

    Recorded this from one of MUC post Looks like your fuel pressure is good With no 5V the ECM doesn't know much. One thing is if there is a bad sensor the motor would start, but if there is low 5V then all the sensors are feeding bad info and the motor won't start
  6. alldodge

    496mag no start issue.

    Fuel pressure should be 39 psi but at 35 it should start. Does fuel pressure stay up when the pump stops or does it drop? Use a spark gap tester and check for spark
  7. alldodge

    Reattach cap to hull

    Is it possible that amidship the cap is sitting a tad lower then it was before? If its lower this will move the stern out further if the bacp sits lower on both ends and higher amidship
  8. alldodge

    VP 5.7 Gi-J three or 4 sparks only

    Good deal, one of Muc guiding principles, don't replace parts till you know something "is" bad
  9. alldodge

    EST1 Open

    The analog gouges are simple enough, need 12 to 14 V, ground and sender providing variable ground. Your reading low so resistance is high or bad connection. Check your connections, voltage and with power OFF measure resistance of sender to helm ground at the gauge
  10. alldodge

    Electric panel toilet switch

    Good point Q, might be for the mercerator, but I think that should keep running until turned of, right?
  11. alldodge

    Dean's List gets another motor

    It's going in a 37ft cruiser, closed cool
  12. alldodge

    Dean's List gets another motor

    Did it yesterday after she left for her sister's in IN. No T day here and will meet her Saturday for T day
  13. alldodge

    Dean's List gets another motor

    It's 60 over and ring gap is in spec. Had to bore one cylinder over 60 and install sleeve. Crank, rods, pistons installed
  14. alldodge

    SWITCH ASSEMBLY, CUT-OUT-TRANSOM PLATE

    Should have posted this in the Merc section because its a motor topic. The switch will be normally open and close contacts when shifting into neutral. Without the switch as you have found its hard to shift out of gear What I said above is only true if the ignition is original, meaning has not...
  15. alldodge

    Electric panel toilet switch

    Well..... normally there is a water pump switch and its just left ON and the pump cycles each time water is needed. Having one mark as toilet maybe done the same way. That said I wouldn't leave either ON when you leave the boat
  16. alldodge

    Darn Mice Can Be Expensive

    Have a bucket trap in the barn and caught a few. Been putting PB in the center and as they walk out the roller turns and they fall in. Now the sort of funny part. Found the PB gone on all they way around and no mouse. Put more on it and next day all gone and no mouse. Set trail cam up and...
  17. alldodge

    2013 F250 6.7 Powerstroke

    Way cool
  18. alldodge

    EST1 Open

    Sender checks out for 240 (cold) to 33 (hot) ohms Put sender in pan a water with thermometer and ohm meter connected to see how it changes as water heats up
  19. alldodge

    EST1 Open

    Good deal What's the part number of the sender?
  20. alldodge

    Reattach cap to hull

    ...
View older results
Top