Search results

  1. Redrig

    89- 5.8l OMC with Holley 4160 flooding problem

    My vote is on power valve as well. I fought the same battle last year . My Fuel screws all the way in and still running rich.
  2. Redrig

    MASSIVE oil leak mechanic can’t find

    throw some dye in the oil and take it for a ride under load . should leave a nice trail wherever its coming from
  3. Redrig

    Electric shift stringer omc stern drive

    on the outside , yes its noticeable. Right where the cable passes through into the boat. tilt the drive all the way up and you have easy access
  4. Redrig

    Electric shift stringer omc stern drive

    there is a clip that has to be unbolted before removing the drive. Its right where the shift cable goes through the intermediate . be sure to remove the clip or you will rip the cable
  5. Redrig

    Electric shift stringer omc stern drive

    yes you can just swap over the drives. If they are both 84's they are not electric shifts , they are mechanical shifts. how are the ball gears on both of them ? anything below 50% wear should be replaced. So if one of the boats has better ball gears swap them over as well. and be very...
  6. Redrig

    Looking for help with electric shift stinger

    Honestly , assuming your upper unit is in decent shape, I would start looking for a new lower unit . Kenny will know more about it , but I am pretty sure to fix yours properly , you will need the new shaft and all of the very hard to find shimming tools . I see those lower units all of the time...
  7. Redrig

    Looking for proper name for this drive

    electric shift stringer is what that is known as . takes type C fluid in the lower
  8. Redrig

    Partial Power... Part of the Time!

    I got lazy one year and didn't file the points and gap , dwell , etc . It was a quick April trip and I figured " it was fine just back in September" the boat ran quite poorly and needless to say I havent done that again . My money is on the same situation for you.
  9. Redrig

    How to wire a tach

    Does it have a light ? you should have 4 wires going to it , not 3. what are the wire colors for your pigtail ? either way it should be really straight forward wiring it up even without the pigtail. The 4 (3 with no light ) wires should be this below. Signal - negative side of coil 12v...
  10. Redrig

    1980 OMC 140hp electrical

    I would imagine so. That's how my Ford 302 is set up. Full battery voltage to the points while cranking. Then with key in "run" position it is fed through a ballast resistor.
  11. Redrig

    How to tel if boat will over heat in the water

    I did exactly that , to a new faria gauge. Works perfectly
  12. Redrig

    Where to Buy

    Being an OMC owner , I would certainly bookmark this page below. it gives the OEM part numbers for everything, you can then search based on those numbers. http://epc.brp.com/Index.aspx?lang=E&s1=8427e6fd-07ba-48af-89af-4ae2760d7523 Ive had good luck finding almost everything needed for my...
  13. Redrig

    Holley 4160 - Flooding Secondary

    Mine is a 2bl , I've never had a 4bl holley , but that sure sounds like a power valve. ( does a 4 barrell have 2 power valves IDK ? ) Mine was doing exact thing last year , pig rich when I could actually get it to run - Power valve was toast . did you replace it during the rebuild ? Ive seen...
  14. Redrig

    Starting circuit

    Yeah , there is a neutral safety switch in the controller to prevent starting while in gear. Yours appears to be toast. And Fyi , the prop will usually spin a little even in neutral when running it in the driveway . With the engine off , can you spin the prop by hand or is there resistance ?
  15. Redrig

    Auto AC stats and questions

    well , I have some good news . I feel like a bit of an idiot though . The thermometer I was using for these readings is about 7-8 degrees off (10-12$ vent one from oreillys) I used the icewater test trick the other night to test its accuracy and yeah , not too accurate at all. So I got another...
  16. Redrig

    Auto AC stats and questions

    So would the vacuum remove all liquids that were in the system ? getting rid of all of the flush ? yeah , I didnt have a scale but I have read about adding the cans using that method . They say to charge at about 80-85% of what the normal R12 charge would be.
  17. Redrig

    Auto AC stats and questions

    Hi , thanks for the response . I used those ac manifold gauges with the 2 dials for low and high pressure. The low pressure side has a gauge with vacuum on it . It pegs out at 30 and that's where the pump and system maxed out at. And the vacuum pump was just a rental from O'Reilly. But yeah...
  18. Redrig

    Auto AC stats and questions

    Hello All , Just this weekend I added a mostly new AC system to my 91 Ford Bronco. I read as many threads as I could and found alot of good info on the webs , just wanted to have some of you AC pros maybe look over my numbers and give me your thoughts. by the way , new denso comp , all new...
  19. Redrig

    Remove 190hp omc tilt motor

    The motor you have in your hand is for later stringer models , what year is that boat ? #11 in this pic shows the bolt we are talking about ( there are 2 that you need to remove ) Feel the end of the motor , in the bilge area . They are 7/16 IIRC
  20. Redrig

    Remove 190hp omc tilt motor

    2 long bolts at the end of that motor (engine side) The motor will try to fall apart as you remove it. its a real PITA
Top