Search results

  1. K

    Cracked exhaust manifold 130 aq

    Barr marine has manifolds for your engine. Just google it
  2. K

    3.0L Fuel Starvation

    There probably a a bag style at the end or a small one in the tube. Try using a straight piece of wire to see if there is one in the tube. If there is none in the tube then usually the tube has a 90* bend at the bottom where the filter bag is attached. Does the tube feel loose, does the...
  3. K

    OMC to Mercruiser Conversion

    The Holley to me is a better set up and the engine should perform good with the Mercruiser. There is a hole on the upper part of the Holley throttle lever to attach the Mercruiser throttle cable. You may have to make up another bracket to anchor the cable.
  4. K

    OMC to Mercruiser Conversion

    2Xs on Bondo’s suggestion. As far as the original Mercruiser engine I would give a lot of thought about the manifolds. They may be the reason the that something is wrong with the Mercruiser. I suggest new manifolds. You can keep your OMC distributor because some Mercruisers also used either...
  5. K

    Looking for help with electric shift stinger

    Lift the top cover off of the upper gear case and check if the centering post is broken off or loose. The only way the spline can break is if there is a mis alignment. That drive unit had to have struck something really hard.
  6. K

    Looking for help with electric shift stinger

    The 6 bolts,are they philips head counter sunk in the top of the upper gear case that holds a cover on? If so then I suspect that the center post in the gear case is broken off which caused the splined water pump shaft to break the spline off of the lower vertical shaft. In other words you have...
  7. K

    Volvo Penta 5.7 Sometimes Halts at 2500 RPM

    Just for kicks, has the water pump impeller been serviced or inspected? Low water pressure will sometime cause what you are describing.
  8. K

    Looking for proper name for this drive

    Try to get a genuine OMC service manual before trying that job.
  9. K

    Strange new water leak in sterndrive

    Are you having a over heat condition? Which engine do you have?
  10. K

    Strange new water leak in sterndrive

    From what I can see it is the jet of water that OMC added to “cool” the ball gears. The down side is it causes water incursion in the upper gear case as the outer seal area on the drive side ball gear’s seal surface wears. If you were to pull the drive back enough to plug the holes would be an...
  11. K

    New to omc bought I think 78

    Put a garden hose in the hose that goes from the transom to the thermostat housing.
  12. K

    Strange tach behavior on a Penta 5.0L

    You will need a new lower gear case or try removing the exhaust bellows to cause the exhaust to blow out before the propeller. Try to compare your gear case to another one where the propeller fits in the gear case just to be sure.
  13. K

    Strange tach behavior on a Penta 5.0L

    The rear of the gear case where the propeller fits in that makes the labyrinth seal looks like some of the rear edge is worn away. If that is the case then too much exhaust is going over the propeller than through it causing cavitation.
  14. K

    Mercruiser 3.0 Exhuast Port Corrosion on Head

    JB weld should work as AD suggested. I bet that the gap where the engine cover meets the rear panel is letting water land on top of the engine. Try to make a shield that will direct the water away from the top of the engine.
  15. K

    Engine is in, successful run?

    Is the fuel pump being controlled through a oil pressure safety switch? If not should the carburetor “flood over” and the engine stops then the fuel pump will keep pumping and a fire could result.
  16. K

    Tuning Holley 80551 (4160)

    Is it a marine carburetor?
  17. K

    Partial Power... Part of the Time!

    Things were pretty crazy when the first Cobras came out. I did a a few re powers which finally was able to straighten out with help from OMC. They were really good with warranty problems and never questioned any of my requests. Mercruiser was a different story sometimes. Petronic ignition...
  18. K

    Partial Power... Part of the Time!

    I wish that OMC would have kept it simpler with the same shift dog from the beginning As Mercruiser. The very first 800s I installed were chewing the dogs up because they used the same 90* dog angles as the outboards. While that same arrangement worked on outboards it did not on stern drives...
  19. K

    Partial Power... Part of the Time!

    Of course OEM is very good, I like most of the Sierra products but I do not know where the ignition parts come from. If foreign parts are made to real factory specs using the same materials then yes I feel that would be good. It is too bad that the Prestolite electronic conversion does not work...
  20. K

    Partial Power... Part of the Time!

    The main thing about points and condensers is only from some place like NAPA. All that foreign junk you should stay away from. If the points have tiny white spots on them that is from moisture, you can file them but they will fail.
Top