Search results

  1. Dukedog

    1999 90 hp 3 cylinder 2 stroke mercury no power, sounds fine

    when you say "half throttle" do you mean position of throttle? what are tha rpms? do you mean tha throttle is all tha way foward but its only moving at what is normally 1/2 "throttle"?.. need ta know what tha rpms readings are when its maxed out with throttle at wfo?
  2. Dukedog

    1998 Mercury 225 slipping at high speeds

    agree, probably set up.. boat type, motor (3.0 or 2.5 PM), offset, height, prop? i always liked a little "wiggle" at times.. kept me on my toes and payin' attention!
  3. Dukedog

    Mariner 175 V6

    stamped BUILD date... look on tha block.. just to tha right of tha block half flange at tha base of number 2 cylinder.. will be kinda right behind tha "bend" in tha timin' arm in tha picture.. m/d/yr in 1/8 inch numbers.. might be hard ta see but it is there.
  4. Dukedog

    1995 Mercury 150 EFI no fuel

    no pressure, sometimes pressure when key is cycled?.. bad pump driver circuit (ecu) or bad pump.. disconnect both + and - from pump.. isolate both and tape up both... find a purple anywhere on tha motor... tie into it and go to + side of pump.. make a new ground from anywhere on tha block and...
  5. Dukedog

    Help identifying star replacement

    i've never ventured down tha road ya lookin' at so i can't say.................
  6. Dukedog

    Help identifying star replacement

    like said, never used cdi anything myself.... sooooooo its up to you.. i did find that pro marine shows it to be a #174-1778 reading tha stuff i see why they are grounding those two "colored" wires.. its to make that stator work on other motors..... one stator with different motor...
  7. Dukedog

    Help identifying star replacement

    never used anything CDI.. color doesn't mean anything amperage.. i do know that tha "ONLY BLACK COLOR " with merc, oem and /or aftermarket is a ground.. at no time will you use a red, blue anything other than black as a ground.. after market part/number should show oem number that its...
  8. Dukedog

    Help identifying star replacement

    i've got 4 merc parts list for that serial number and all 4 show same stator.. part # 398-832075A5 some sites will give a "range" of sorts but those include superceded numbers that all point to same part.................. ie: 832075A5 < 9710A30
  9. Dukedog

    Did I make a bad mistake?

    you will never know tha difference.. use a remote starter button or pull tha kill switch.. should be on tha control box? send me an email address and i'll send ya an OEM manual in pdf for it.
  10. Dukedog

    Did I make a bad mistake?

    tex is not tha over temp.. its for a temp gauge.. tha over temp (tha one in tha plastic sleeve) terminates on a small term block with a tan that comes from a pin in tha harness. tha tan with tha bullet connector will plug into an exposed tan on tha MALE side of harness plug...
  11. Dukedog

    Did I make a bad mistake?

    don't know where ya gettin' your info but this what ya got'''' 1994 Mercury Outboard 135 [XL] [ 1135422PD ]
  12. Dukedog

    Did I make a bad mistake?

    sorry but that is not an '03.. its pre 2000. tha clamp/trim may be but not powerhead.. check for tha build date i mentioned.
  13. Dukedog

    Did I make a bad mistake?

    before ya start with buyin' parts.. first thing before ya start ta move tha pistons, squirt a tad bit of pre-mix in tha cylinders and in tha carburetors ta free up tha rings maybe... use a remote start button.. do not use ign key ta turn it over unless ya pull tha kill lanyard.. does it turn...
  14. Dukedog

    mercury 175xri warning module

    with module and sensors all made up with power (purple) and alarm (tan/blue) made up on tha small term block its like its all still in "function" mode but may/may not be causin' a false narrative for what ever reason.. but not to worry 'bout tha over temp alarm.. oiler stuff and ecu/acu have...
  15. Dukedog

    mercury 175xri warning module

    tha oiler stuff has no connection to tha over heat alarm other than sharing tha same buzzer.. tha ecu/acu has no connection to tha oil injection stuff either... you are doin' somethin' i've never tried.. i have not and don't know of anyone that went to pre-mix and left power (purple) and signal...
  16. Dukedog

    mercury 175xri warning module

    you say tha oiler is not being used but module still has power? are all sensors still in place and still made up to tha module?.. do you still get tha "self test" beeps when key switch is rotated? oiler stuff and acu/ecu aren't connected in any way.........
  17. Dukedog

    Lower unit

    he should have tha bigger case.. small case only came on XR4 and early XR6..
  18. Dukedog

    Merc's External 2 Stroke Oil Tank.-

    Faz... plain 'ole (switch box maybe) efi motor.. no nothing' but a buzzer.
  19. Dukedog

    Merc's External 2 Stroke Oil Tank.-

    thats why i was askin'............. oiler anything has nothin' ta do with tha runnin' part of it.. no guardian (limp) mode.. ya got something else goin' on.............
  20. Dukedog

    Merc's External 2 Stroke Oil Tank.-

    what year?.. regular 2 stroke or opti?
Top