Search results

  1. R

    Prop pitch for 150xp crossflow on pontoon

    There are lots of toons with monster motors.
  2. R

    Add telltale pee hole to 1965 Johnson 75 HP

    The exhaust relief on a V-4 75 HP in 1965 is a better item than a tell tale on many modern motors !------At full throttle water pours out of there.----Then when you slow down the hot water / water vapor pours out until thermostat controls temperature and water just spits out.--Tell you all is...
  3. R

    Water Separator , larger filter verses smaller filter

    If boat is left in the water use a large filter.----If it lives in the driveway a smaller filter will do.
  4. R

    1964 9.5 evinrude

    My guess is that you have never seen a cylinder wall of a " new condition " motor.----Your motor needs to come apart.----Needs to be bored and oversize pistons fitted.---Returned to new factory fit and finish.-----I doubt you can find these parts today.----Find good used parts on E-bay...
  5. R

    1964 9.5 evinrude

    Sometimes it is hard for folks to accept the truth from people who have worked on many of these motors since 1968.----Have all kinds of parts for those motors.----Boxes full of good parts.
  6. R

    1964 9.5 evinrude

    The motor appears to have been run on straight gas and no oil oil the mix..---It is JUNK now.----Beyond economical repair.
  7. R

    1964 9.5 evinrude

    The pictures now show what I suspected.----Motor needs to come apart for a rebuild.---Simple as that.---It is JUNK.
  8. R

    1964 9.5 evinrude

    Good luck with your motor.---You have in under control.
  9. R

    1963 Evinrude Mate 2 hp impeller

    I only use factory impellers.----Not worth trying to save a few $$ on a critical part.
  10. R

    1964 9.5 evinrude

    Out of focus and does not show fine detail.---Try again.
  11. R

    1963 Evinrude Mate 2 hp impeller

    That impeller or the improved water pump kit should be in stock at most BRP ( Evinrude ) shops.----That is if you can find one.----In Canada---evinrudeparts.ca----Is one source.
  12. R

    Yamaha 90 hp 2 stroke

    Time to take it apart for inspection.-----Used parts might be available.-----Your location ?
  13. R

    1964 9.5 evinrude

    Post more pictures of the bottom cylinder wall.----Does not look good to me.
  14. R

    1964 9.5 evinrude

    Water must be 8" above impelle in your test bucket.-----Give some details as to what is " new " on this motor !!
  15. R

    1963 Evinrude Mate 2 hp impeller

    No such thing as a 2 HP in 1963.-----Model # or picture?====The 1.5 HP was first marketed in 1968.
  16. R

    Mercury outboard blowing steam

    Check the NLA fitting and grommet found at the top of the water tube.----If bad you have to find a used one or make one.-----Check water jackets for debris / old impeller bits.------And if there was severe overheat post your compression numbers.
  17. R

    Prop pitch for 150xp crossflow on pontoon

    Sorry---I guess I missed the " rebuilt " part in post #1.
  18. R

    impeller. 82 50 hp 4 cyl

    That impeller was used for a lot of years.----A good shop would have it in stock !!
  19. R

    Prop pitch for 150xp crossflow on pontoon

    A 15" pitch would be a good starting point.----Is the motor in good shape?----For reference in the future do a compression test.----Post the actual values here.
  20. R

    Merc 75 4 cylinders, 2 carbs

    This LaqueRatt does NOT invest in manuals.----Refuses to do so !
Top